Messages in this thread | | | Subject | Re: [PATCH v3 net-next 0/7] net: dsa: add support for RTL8365MB-VC | From | Arınç ÜNAL <> | Date | Sat, 16 Oct 2021 12:13:26 +0300 |
| |
Tested on net-next master branch kernel on Asus RT-AC88U router using OpenWrt.
DT specification:
ethernet-switch { compatible = "realtek,rtl8365mb"; mdc-gpios = <&chipcommon 6 GPIO_ACTIVE_HIGH>; mdio-gpios = <&chipcommon 7 GPIO_ACTIVE_HIGH>; reset-gpios = <&chipcommon 10 GPIO_ACTIVE_LOW>; realtek,disable-leds; dsa,member = <1 0>;
ports { #address-cells = <1>; #size-cells = <0>; reg = <0>;
port@0 { reg = <0>; label = "lan5"; phy-handle = <ðphy0>; };
port@1 { reg = <1>; label = "lan6"; phy-handle = <ðphy1>; };
port@2 { reg = <2>; label = "lan7"; phy-handle = <ðphy2>; };
port@3 { reg = <3>; label = "lan8"; phy-handle = <ðphy3>; };
port@6 { reg = <6>; label = "cpu"; ethernet = <&sw0_p5>; phy-mode = "rgmii"; tx-internal-delay-ps = <2000>; rx-internal-delay-ps = <2000>;
fixed-link { speed = <1000>; full-duplex; pause; }; }; };
mdio { compatible = "realtek,smi-mdio"; #address-cells = <1>; #size-cells = <0>;
ethphy0: phy@0 { reg = <0>; };
ethphy1: phy@1 { reg = <1>; };
ethphy2: phy@2 { reg = <2>; };
ethphy3: phy@3 { reg = <3>; }; }; };
Tested-by: Arınç ÜNAL <arinc.unal@arinc9.com>
| |