lkml.org 
[lkml]   [2021]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH v2 07/14] cxl/mem: Implement polled mode mailbox
On 20-12-08 16:24:11, Ben Widawsky wrote:

[snip]

> +static int cxl_mem_mbox_send_cmd(struct cxl_mem *cxlm,
> + struct mbox_cmd *mbox_cmd)
> +{
> + u64 cmd, status;
> + size_t out_len;
> + int rc;
> +
> + lockdep_assert_held(&cxlm->mbox_lock);
> +
> + /*
> + * Here are the steps from 8.2.8.4 of the CXL 2.0 spec.
> + * 1. Caller reads MB Control Register to verify doorbell is clear
> + * 2. Caller writes Command Register
> + * 3. Caller writes Command Payload Registers if input payload is non-empty
> + * 4. Caller writes MB Control Register to set doorbell
> + * 5. Caller either polls for doorbell to be clear or waits for interrupt if configured
> + * 6. Caller reads MB Status Register to fetch Return code
> + * 7. If command successful, Caller reads Command Register to get Payload Length
> + * 8. If output payload is non-empty, host reads Command Payload Registers
> + */
> +
> + /* #1 */
> + WARN_ON(cxl_doorbell_busy(cxlm));
> +
> + /* #2 */
> + cxl_write_mbox_reg64(cxlm, CXLDEV_MB_CMD_OFFSET, mbox_cmd->opcode);
> +
> + if (mbox_cmd->size_in) {
> + /* #3 */
> + CXL_SET_FIELD(mbox_cmd->size_in, CXLDEV_MB_CMD_PAYLOAD_LENGTH);
> + cxl_mbox_payload_fill(cxlm, mbox_cmd->payload,
> + mbox_cmd->size_in);
> + }

There is a bug here where the payload length isn't written on input. It was
working in v1. It will be fixed in v3.

[snip]

\
 
 \ /
  Last update: 2021-01-07 20:06    [W:1.941 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site