lkml.org 
[lkml]   [2021]   [Jan]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 5.10 00/40] 5.10.3-rc1 review
From
Date
On Wed, 2021-01-06 at 20:49 +0100, Greg Kroah-Hartman wrote:
> On Thu, Jan 07, 2021 at 01:08:01AM +0530, Jeffrin Jose T wrote:
> > On Mon, 2021-01-04 at 07:21 +0100, Greg Kroah-Hartman wrote:
> > > On Sun, Jan 03, 2021 at 06:37:51PM +0530, Jeffrin Jose T wrote:
> > > > On Mon, 2020-12-28 at 12:41 -0800, Guenter Roeck wrote:
> > > > > On 12/28/20 1:50 AM, Pavel Machek wrote:
> > > > > > Hi!
> > > > > >
> > > > > > > > > > > > https://www.kernel.org/pub/linux/kernel/v5.x/stable-review/patch-5.10.3-rc1.gz
> > > > > > > > > > > > or in the git tree and branch at:
> > > > > > > > > > > >         git://git.kernel.org/pub/scm/linux/kern
> > > > > > > > > > > > el/g
> > > > > > > > > > > > it/s
> > > > > > > > > > > > table/
> > > > > > > > > > > > linu
> > > > > > > > > > > > x-
> > > > > > > > > > > > stable-rc.git linux-5.10.y
> > > > > > > > > > > > and the diffstat can be found below.
> > > > > > > > > > > >
> > > > > > > > > > > > thanks,
> > > > > > > > > > > >
> > > > > > > > > > > > greg k-h
> > > > > > > > > > >
> > > > > > > > > > > hello ,
> > > > > > > > > > > Compiled and booted 5.10.3-rc1+.
> > > > > > > > > > >
> > > > > > > > > > > dmesg -l err gives...
> > > > > > > > > > > --------------x-------------x------------------->
> > > > > > > > > > >    43.190922] Bluetooth: hci0: don't support
> > > > > > > > > > > firmware
> > > > > > > > > > > rome
> > > > > > > > > > > 0x31010100
> > > > > > > > > > > --------------x---------------x----------------->
> > > > > > > > > > >
> > > > > > > > > > > My Bluetooth is Off.
> > > > > > > > > >
> > > > > > > > > > Is this a new warning?  Does it show up on 5.10.2?
> > > > > > > > > >
> > > > > > > > > > > Tested-by: Jeffrin Jose T <
> > > > > > > > > > > jeffrin@rajagiritech.edu.in>
> > > > > > > > > >
> > > > > > > > > > thanks for testing?
> > > > > > > > > >
> > > > > > > > > > greg k-h
> > > > > > > > >
> > > > > > > > > this does not show up in 5.10.2-rc1+
> > > > > > > >
> > > > > > > > Odd.  Can you run 'git bisect' to find the offending
> > > > > > > > commit?
> > > > > > > >
> > > > > > > > Does this same error message show up in Linus's git
> > > > > > > > tree?
> > > > > >
> > > > > > > i will try to do "git bisect" .  i saw this error in
> > > > > > > linus's 
> > > > > > > tree.
> > > > > >
> > > > > > The bug is in -stable, too, so it is probably easiest to do
> > > > > > bisect
> > > > > > on
> > > > > > -stable tree. IIRC there's less then few hundred commits,
> > > > > > so it
> > > > > > should
> > > > > > be feasible to do bisection by hand if you are not familiar
> > > > > > with
> > > > > > git
> > > > > > bisect.
> > > > > >
> > > > >
> > > > > My wild guess would be commit b260e4a68853 ("Bluetooth: Fix
> > > > > slab-
> > > > > out-
> > > > > of-bounds
> > > > > read in hci_le_direct_adv_report_evt()"), but I don't see
> > > > > what
> > > > > might
> > > > > be wrong
> > > > > with it unless some BT device sends a bad report which used
> > > > > to be
> > > > > accepted
> > > > > but is now silently ignored.
> > > > >
> > > > > Guenter
> > > > >
> > > > hello,
> > > >
> > > > Did  "git bisect" in  a typically ok fashion and found that
> > > > 5.9.0
> > > > is
> > > > working for bluetooth related. But 5.10.0-rc1  related is not
> > > > working.
> > > >
> > > > some related information in bisect.txt  attached.
> > > >
> > > > --
> > > > software engineer
> > > > rajagiri school of engineering and technology - autonomous
> > > >
> > >
> > > > $sudo git bisect bad
> > > > Bisecting: 0 revisions left to test after this (roughly 1 step)
> > > > [194810f78402128fe07676646cf9027fd3ed431c] dt-bindings: leds:
> > > > Update devicetree documents for ID_RGB
> > > >
> > > > $sudo git bisect bad
> > > > Bisecting: 0 revisions left to test after this (roughly 0
> > > > steps)
> > > > [3650b228f83adda7e5ee532e2b90429c03f7b9ec] Linux 5.10-rc1
> > >
> > > That's really odd, as that commit only has a Makefile change.
> >
> > i will try to work on it again
> >
> > > Also, why run this as root?
> > >
> > there may be some problem in my sudo configurtion or the way in run
> > sudo.\
> > when i run "make modules_install" and "make install" using sudo
> > typical
> > files 
> > ownership changes to root.
>
> That's fine when installing the kernel, but not when building or
> running
> git, please don't do that.

ok related .

\
 
 \ /
  Last update: 2021-01-07 00:57    [W:0.074 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site