lkml.org 
[lkml]   [2020]   [Sep]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/5] usb: dwc-meson-g12a: Add support for USB on AXG SoCs
Date
The Amlogic AXG is close from the GXL Glue but with a single OTG PHY.

It needs the same init sequence as GXL & GXM, but it seems it doesn't need
the host disconnect bit.

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
---
drivers/usb/dwc3/dwc3-meson-g12a.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)

diff --git a/drivers/usb/dwc3/dwc3-meson-g12a.c b/drivers/usb/dwc3/dwc3-meson-g12a.c
index 1f7f4d88ed9d..90275c13c224 100644
--- a/drivers/usb/dwc3/dwc3-meson-g12a.c
+++ b/drivers/usb/dwc3/dwc3-meson-g12a.c
@@ -215,6 +215,19 @@ static struct dwc3_meson_g12a_drvdata gxm_drvdata = {
.usb_post_init = dwc3_meson_gxl_usb_post_init,
};

+static struct dwc3_meson_g12a_drvdata axg_drvdata = {
+ .otg_switch_supported = true,
+ .clks = meson_gxl_clocks,
+ .num_clks = ARRAY_SIZE(meson_gxl_clocks),
+ .phy_names = meson_a1_phy_names,
+ .num_phys = ARRAY_SIZE(meson_a1_phy_names),
+ .setup_regmaps = dwc3_meson_gxl_setup_regmaps,
+ .usb2_init_phy = dwc3_meson_gxl_usb2_init_phy,
+ .set_phy_mode = dwc3_meson_gxl_set_phy_mode,
+ .usb_init = dwc3_meson_g12a_usb_init,
+ .usb_post_init = dwc3_meson_gxl_usb_post_init,
+};
+
static struct dwc3_meson_g12a_drvdata g12a_drvdata = {
.otg_switch_supported = true,
.clks = meson_g12a_clocks,
@@ -930,6 +943,10 @@ static const struct of_device_id dwc3_meson_g12a_match[] = {
.compatible = "amlogic,meson-gxm-usb-ctrl",
.data = &gxm_drvdata,
},
+ {
+ .compatible = "amlogic,meson-axg-usb-ctrl",
+ .data = &axg_drvdata,
+ },
{
.compatible = "amlogic,meson-g12a-usb-ctrl",
.data = &g12a_drvdata,
--
2.22.0
\
 
 \ /
  Last update: 2020-09-09 18:52    [W:0.130 / U:6.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site