lkml.org 
[lkml]   [2020]   [Sep]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v2 0/5] usb: dwc-meson-g12a: Add support for USB on S400 board
Date
The Amlogic AXG is close to the GXL Glue but with a single OTG PHY.

It needs the same init sequence as GXL & GXM, but it seems it doesn't need
the host disconnect bit.

The Glue driver reuses the already implemented GXL & GXM work.

The USB2 PHY driver needs a slight tweak to keep the OTG detection working.

Changes since v1 at [1]:
- s/close from/close to/g
- collected review tags
- added small comment about phy management in patch 3
- removed status = "okay" in patch 4
- removed invalid phy-supply of phy1 in patch 5

[1] http://lore.kernel.org/r/20200909160409.8678-1-narmstrong@baylibre.com

Neil Armstrong (5):
phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG
Families USB Glue Bindings
usb: dwc-meson-g12a: Add support for USB on AXG SoCs
arm64: dts: meson-axg: add USB nodes
arm64: dts: meson-axg-s400: enable USB OTG

.../usb/amlogic,meson-g12a-usb-ctrl.yaml | 22 +++++++-
.../arm64/boot/dts/amlogic/meson-axg-s400.dts | 6 +++
arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 50 +++++++++++++++++++
drivers/phy/amlogic/phy-meson-gxl-usb2.c | 3 +-
drivers/usb/dwc3/dwc3-meson-g12a.c | 18 +++++++
5 files changed, 97 insertions(+), 2 deletions(-)

--
2.22.0

\
 
 \ /
  Last update: 2020-09-17 09:05    [W:0.114 / U:0.884 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site