lkml.org 
[lkml]   [2020]   [Sep]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] ARM: dts: document pinctrl-single,pins when #pinctrl-cells = 2
On Thu, Sep 17, 2020 at 2:20 AM Drew Fustini <drew@beagleboard.org> wrote:
>
> On Thu, Sep 17, 2020 at 02:03:46AM -0700, Trent Piepho wrote:
> > On Mon, Sep 14, 2020 at 3:44 AM Drew Fustini <drew@beagleboard.org> wrote:
> > >
> > > +
> > > +When #pinctrl-cells = 2, then setting a pin for a device could be done with:
> > > +
> > > + pinctrl-single,pins = <0xdc 0x30 0x07>;
> > > +
> > > +Where 0x30 is the pin configuration value and 0x07 is the pin mux mode value.
> > > +See the device example and static board pins example below for more information.
> >
> > Pin configuration and mux mode don't mean anything in pinctrl-single.
> > On another machine, mux mode might not be programmed this way or even
> > exist. Or the location of bits would probably be different, and this
> > would seem to imply the 0x07 would get shifted to the correct location
> > for where the pin mux setting was on that machine's pinctrl registers.
> >
> > It seems like it would be better to explain the values are ORed together.
>
> I descirbed it as seoerate values as I did not want to prescribe what
> the pcs driver would do with those values. But, yes, it is a just an OR
> operation, so I could change the language to reflect tat.

If you don't say what the pinctrl-single driver does with the values,
how would anyone know how to use it?

> > What is the purpose of this change anyway? It seems like in the end
> > it just does what it did before. The data is now split into two cells
> > in the device tree, but why?
>
> These changes were a result of desire to seperate pinconf and pinmux.
> Tony raised the idea in a thread at the end of May [1].
>
> Tony wrote:
> > Only slightly related, but we should really eventually move omaps to use
> > #pinctrl-cells = <2> (or 3) instead of 1, and pass the pinconf seprately
> > from the mux mode. We already treat them separately with the new
> > AM33XX_PADCONF macro, so we'd only have to change one SoC at a time to
> > use updated #pinctrl-cells. But I think pinctrl-single might need some
> > changes before we can do that.

I still don't see what the goal is here. Support generic pinconf?

Also note that while AM33XX_PADCONF() is changed, there is an in tree
board that doesn't use it, so it's broken now. I found this change
when it broke my out of tree board, due to the dtsi change not being
reflected in my board's pinctrl values.

\
 
 \ /
  Last update: 2020-09-17 12:01    [W:0.083 / U:1.656 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site