lkml.org 
[lkml]   [2020]   [Jun]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v3 104/105] dt-bindings: display: vc4: hdmi: Add BCM2711 HDMI controllers bindings
On Tue, Jun 2, 2020 at 9:08 AM Maxime Ripard <maxime@cerno.tech> wrote:
>
> Hi Rob,
>
> On Fri, May 29, 2020 at 12:18:33PM -0600, Rob Herring wrote:
> > On Wed, May 27, 2020 at 05:49:14PM +0200, Maxime Ripard wrote:
> > > The HDMI controllers found in the BCM2711 SoC need some adjustments to the
> > > bindings, especially since the registers have been shuffled around in more
> > > register ranges.
> > >
> > > Cc: Rob Herring <robh+dt@kernel.org>
> > > Cc: devicetree@vger.kernel.org
> > > Signed-off-by: Maxime Ripard <maxime@cerno.tech>
> > > ---
> > > Documentation/devicetree/bindings/display/brcm,bcm2711-hdmi.yaml | 109 ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++-
> > > 1 file changed, 109 insertions(+)
> > > create mode 100644 Documentation/devicetree/bindings/display/brcm,bcm2711-hdmi.yaml
> > >
> > > diff --git a/Documentation/devicetree/bindings/display/brcm,bcm2711-hdmi.yaml b/Documentation/devicetree/bindings/display/brcm,bcm2711-hdmi.yaml
> > > new file mode 100644
> > > index 000000000000..6091fe3d315b
> > > --- /dev/null
> > > +++ b/Documentation/devicetree/bindings/display/brcm,bcm2711-hdmi.yaml
> > > @@ -0,0 +1,109 @@
> > > +# SPDX-License-Identifier: GPL-2.0
> >
> > Dual license...
> >
> > > +%YAML 1.2
> > > +---
> > > +$id: http://devicetree.org/schemas/display/brcm,bcm2711-hdmi.yaml#
> > > +$schema: http://devicetree.org/meta-schemas/core.yaml#
> > > +
> > > +title: Broadcom BCM2711 HDMI Controller Device Tree Bindings
> > > +
> > > +maintainers:
> > > + - Eric Anholt <eric@anholt.net>
> > > +
> > > +properties:
> > > + compatible:
> > > + enum:
> > > + - brcm,bcm2711-hdmi0
> > > + - brcm,bcm2711-hdmi1
> >
> > What's the difference between the 2 blocks?
>
> The register layout and the lane mapping in the PHY change a bit.
>
> > > +
> > > + reg:
> > > + items:
> > > + - description: HDMI controller register range
> > > + - description: DVP register range
> > > + - description: HDMI PHY register range
> > > + - description: Rate Manager register range
> > > + - description: Packet RAM register range
> > > + - description: Metadata RAM register range
> > > + - description: CSC register range
> > > + - description: CEC register range
> > > + - description: HD register range
> > > +
> > > + reg-names:
> > > + items:
> > > + - const: hdmi
> > > + - const: dvp
> > > + - const: phy
> > > + - const: rm
> > > + - const: packet
> > > + - const: metadata
> > > + - const: csc
> > > + - const: cec
> > > + - const: hd
> > > +
> > > + clocks:
> > > + description: The HDMI state machine clock
> > > +
> > > + clock-names:
> > > + const: hdmi
> > > +
> > > + ddc:
> > > + allOf:
> > > + - $ref: /schemas/types.yaml#/definitions/phandle
> > > + description: >
> > > + Phandle of the I2C controller used for DDC EDID probing
> >
> > Goes in the connector.
> >
> > And isn't the standard name ddc-i2c-bus?
> >
> > > +
> > > + hpd-gpios:
> > > + description: >
> > > + The GPIO pin for the HDMI hotplug detect (if it doesn't appear
> > > + as an interrupt/status bit in the HDMI controller itself)
> >
> > Goes in the connector.
>
> If this was an entirely new binding, I would agree, but this is not
> really the case here.
>
> We discussed it already for the v2, and this binding is essentially the
> same one than the bcm2835 HDMI controller.
>
> I initially sent a patch adding conditionnals for the clocks and regs
> differences too, and you asked to split the binding into a separate file
> to simplify it a bit.

Ah... Best to assume I don't remember what happened last week. ;)

> Supporting both the old binding, and the new one based on the connector
> is going to make the code significantly more complicated, and I'm not
> really sure why we would here.

I'm not really sure I agree on the complexity, but that can be a
discussion for another day.

Reviewed-by: Rob Herring <robh@kernel.org>

Rob

\
 
 \ /
  Last update: 2020-06-09 01:02    [W:0.097 / U:1.336 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site