lkml.org 
[lkml]   [2020]   [Jun]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3] xhci: Prevent runtime suspend on Etron EJ168
From
Date


> On May 5, 2020, at 01:16, Kai-Heng Feng <kai.heng.feng@canonical.com> wrote:
>
> Etron EJ168 USB 3.0 Host Controller stops working after S3, if it was
> runtime suspended previously:
> [ 370.080359] pci 0000:02:00.0: can't change power state from D3cold to D0 (config space inaccessible)
> [ 370.080477] xhci_hcd 0000:04:00.0: can't change power state from D3cold to D0 (config space inaccessible)
> [ 370.080532] pcieport 0000:00:1c.0: DPC: containment event, status:0x1f05 source:0x0200
> [ 370.080533] pcieport 0000:00:1c.0: DPC: ERR_FATAL detected
> [ 370.080536] xhci_hcd 0000:04:00.0: can't change power state from D3hot to D0 (config space inaccessible)
> [ 370.080552] xhci_hcd 0000:04:00.0: AER: can't recover (no error_detected callback)
> [ 370.080566] usb usb3: root hub lost power or was reset
> [ 370.080566] usb usb4: root hub lost power or was reset
> [ 370.080572] xhci_hcd 0000:04:00.0: Host halt failed, -19
> [ 370.080574] xhci_hcd 0000:04:00.0: Host not accessible, reset failed.
> [ 370.080575] xhci_hcd 0000:04:00.0: PCI post-resume error -19!
> [ 370.080586] xhci_hcd 0000:04:00.0: HC died; cleaning up
>
> This can be fixed by not runtime suspend the controller at all.
>
> So disable runtime suspend for EJ168 xHCI device.
>
> Signed-off-by: Kai-Heng Feng <kai.heng.feng@canonical.com>

A gentle ping...

> ---
> v3:
> - Balance rpm refcount in remove callback.
>
> v2:
> - Use a new quirk to avoid changing existing behavior.
>
> drivers/usb/host/xhci-pci.c | 7 ++++++-
> drivers/usb/host/xhci.h | 1 +
> 2 files changed, 7 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
> index 766b74723e64..67b4b433a93e 100644
> --- a/drivers/usb/host/xhci-pci.c
> +++ b/drivers/usb/host/xhci-pci.c
> @@ -227,6 +227,7 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
> xhci->quirks |= XHCI_RESET_ON_RESUME;
> xhci->quirks |= XHCI_TRUST_TX_LENGTH;
> xhci->quirks |= XHCI_BROKEN_STREAMS;
> + xhci->quirks |= XHCI_DISABLE_RUNTIME_SUSPEND;
> }
> if (pdev->vendor == PCI_VENDOR_ID_RENESAS &&
> pdev->device == 0x0014) {
> @@ -371,7 +372,8 @@ static int xhci_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
> xhci->shared_hcd->can_do_streams = 1;
>
> /* USB-2 and USB-3 roothubs initialized, allow runtime pm suspend */
> - pm_runtime_put_noidle(&dev->dev);
> + if (!(xhci->quirks & XHCI_DISABLE_RUNTIME_SUSPEND))
> + pm_runtime_put_noidle(&dev->dev);
>
> if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
> pm_runtime_allow(&dev->dev);
> @@ -397,6 +399,9 @@ static void xhci_pci_remove(struct pci_dev *dev)
> if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
> pm_runtime_forbid(&dev->dev);
>
> + if (!(xhci->quirks & XHCI_DISABLE_RUNTIME_SUSPEND))
> + pm_runtime_get_noresume(&dev->dev);
> +
> if (xhci->shared_hcd) {
> usb_remove_hcd(xhci->shared_hcd);
> usb_put_hcd(xhci->shared_hcd);
> diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
> index 86cfefdd6632..d9c209a10d3f 100644
> --- a/drivers/usb/host/xhci.h
> +++ b/drivers/usb/host/xhci.h
> @@ -1873,6 +1873,7 @@ struct xhci_hcd {
> #define XHCI_DEFAULT_PM_RUNTIME_ALLOW BIT_ULL(33)
> #define XHCI_RESET_PLL_ON_DISCONNECT BIT_ULL(34)
> #define XHCI_SNPS_BROKEN_SUSPEND BIT_ULL(35)
> +#define XHCI_DISABLE_RUNTIME_SUSPEND BIT_ULL(36)
>
> unsigned int num_active_eps;
> unsigned int limit_active_eps;
> --
> 2.17.1
>

\
 
 \ /
  Last update: 2020-06-08 05:57    [W:0.073 / U:8.132 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site