[lkml]   [2020]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v5 4/9] ARM: dts: bcm2711: Add reset controller to xHCI node

On 6/29/2020 9:18 AM, Nicolas Saenz Julienne wrote:
> The chip is hardwired to the board's PCIe bus and needs to be properly
> setup trough a firmware routine after a PCI fundamental reset. Pass the
> reset controller phandle that takes care of triggering the
> initialization to the relevant PCI device.
> Signed-off-by: Nicolas Saenz Julienne <>

Reviewed-by: Florian Fainelli <>

 \ /
  Last update: 2020-06-29 23:18    [W:0.053 / U:1.380 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site