lkml.org 
[lkml]   [2020]   [Jun]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v6 3/3] serial: 8250_dw: Fix common clocks usage race condition
On Thu, Jun 18, 2020 at 1:50 AM Serge Semin
<Sergey.Semin@baikalelectronics.ru> wrote:
>
> The race condition may happen if the UART reference clock is shared with
> some other device (on Baikal-T1 SoC it's another DW UART port). In this
> case if that device changes the clock rate while serial console is using
> it the DW 8250 UART port might not only end up with an invalid uartclk
> value saved, but may also experience a distorted output data since
> baud-clock could have been changed. In order to fix this lets at least
> try to adjust the 8250 port setting like UART clock rate in case if the
> reference clock rate change is discovered. The driver will call the new
> method to update 8250 UART port clock rate settings. It's done by means of
> the clock event notifier registered at the port startup and unregistered
> in the shutdown callback method.
>
> Note 1. In order to avoid deadlocks we had to execute the UART port update
> method in a dedicated deferred work. This is due to (in my opinion
> redundant) the clock update implemented in the dw8250_set_termios()
> method.
> Note 2. Before the ref clock is manually changed by the custom
> set_termios() function we swap the port uartclk value with new rate
> adjusted to be suitable for the requested baud. It is necessary in
> order to effectively disable a functionality of the ref clock events
> handler for the current UART port, since uartclk update will be done
> a bit further in the generic serial8250_do_set_termios() function.

So, regarding runtime PM...

> +static void dw8250_clk_work_cb(struct work_struct *work)
> +{
> + struct dw8250_data *d = work_to_dw8250_data(work);
> + struct uart_8250_port *up;
> + unsigned long rate;
> +
> + rate = clk_get_rate(d->clk);
> + if (rate <= 0)
> + return;
> +

> + up = serial8250_get_port(d->data.line);

(Btw, this can be done directly in the definition block above.)

> + serial8250_update_uartclk(&up->port, rate);

This I think should require a device to be powered on. What in your
opinion is a better place to have it done?
To me it looks like serial8250_update_uartclk() misses it.

> +}

--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2020-06-18 10:30    [W:0.214 / U:0.132 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site