[lkml]   [2020]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH] mm/zswap.c: Fix typo accept_threshold_percent in Documentation/vm/zswap.rst
Recently, I switched over from swap-file to zramswap.

When reading the Documentation/vm/zswap.rst file I fell over this typo.

The parameter is called accept_threshold_percent not accept_threhsold_percent
in /sys/module/zswap/parameters/ directory.

Fixes: 45190f01dd402 ("mm/zswap.c: add allocation hysteresis if pool limit is hit")
Signed-off-by: Sedat Dilek <>
Documentation/vm/zswap.rst | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/vm/zswap.rst b/Documentation/vm/zswap.rst
index f8c6a79d7c70..d8d9fa4a1f0d 100644
--- a/Documentation/vm/zswap.rst
+++ b/Documentation/vm/zswap.rst
@@ -140,10 +140,10 @@ without any real benefit but with a performance drop for the system), a
special parameter has been introduced to implement a sort of hysteresis to
refuse taking pages into zswap pool until it has sufficient space if the limit
has been hit. To set the threshold at which zswap would start accepting pages
-again after it became full, use the sysfs ``accept_threhsold_percent``
+again after it became full, use the sysfs ``accept_threshold_percent``
attribute, e. g.::

- echo 80 > /sys/module/zswap/parameters/accept_threhsold_percent
+ echo 80 > /sys/module/zswap/parameters/accept_threshold_percent

Setting this parameter to 100 will disable the hysteresis.

 \ /
  Last update: 2020-06-01 01:16    [W:0.023 / U:1.536 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site