lkml.org 
[lkml]   [2020]   [May]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 3/6] dt-bindings: serdev: ngsm: Add binding for GNSS child node
On Wed, May 27, 2020 at 01:28:17PM -0600, Rob Herring wrote:
> On Tue, May 12, 2020 at 02:47:10PM -0700, Tony Lindgren wrote:
> > For motorola modem case, we may have a GNSS device on channel 4.
> > Let's add that to the binding and example.
> >
> > Signed-off-by: Tony Lindgren <tony@atomide.com>
> > ---
> > .../devicetree/bindings/serdev/serdev-ngsm.yaml | 9 +++++++++
> > 1 file changed, 9 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/serdev/serdev-ngsm.yaml b/Documentation/devicetree/bindings/serdev/serdev-ngsm.yaml
> > --- a/Documentation/devicetree/bindings/serdev/serdev-ngsm.yaml
> > +++ b/Documentation/devicetree/bindings/serdev/serdev-ngsm.yaml
> > @@ -42,6 +42,10 @@ allOf:
> > description: Name of the USB PHY
> > const: usb
> >
> > + compatible:
> > + description: GNSS receiver
> > + const: motorola,mapphone-mdm6600-gnss
>
> I'm not sure how this isn't failing on the example because it is wrong.
>
> You're saying this compatible belongs at the same level as
> phys/phy-names, but that would be the parent which already has a
> compatible. You have to define a child node property (gnss@4) and have
> 'compatible' under it. At that point, this schema becomes very much
> Motorola specific.
>
> > +
> > required:
> > - phys
> > - phy-names
> > @@ -61,4 +65,9 @@ examples:
> > phy-names = "usb";
> > #address-cells = <1>;
> > #size-cells = <0>;
> > +
> > + gnss@4 {
> > + compatible = "motorola,mapphone-mdm6600-gnss";
> > + reg = <4>;
> > + };
> > };
> > --
> > 2.26.2

And since we're describing a mux, I think you need nodes for the virtual
ports rather than a reg property in what should be a serial client. That
is something like

serial@nnn {
modem {
compatible = "etsi,ts27001-mux";

serial@4 {
compatible = "etsi,ts27001-serial";
reg = <4>;

gnss {
compatible = "motorola,motmdm-gnss";
};
};
};
};

This way you can actually use serdev for the client drivers (e.g. for
gnss), and those drivers also be used for non-muxed ports if needed
(e.g. over USB).

Johan

\
 
 \ /
  Last update: 2020-05-28 11:53    [W:0.441 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site