lkml.org 
[lkml]   [2020]   [May]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] PCI: aardvark: Don't touch PCIe registers if no card connected
On Thu, May 28, 2020 at 06:38:09PM +0200, Pali Rohár wrote:
> On Thursday 28 May 2020 11:26:04 Bjorn Helgaas wrote:
> > On Thu, May 28, 2020 at 04:31:41PM +0200, Pali Rohár wrote:
> > > When there is no PCIe card connected and advk_pcie_rd_conf() or
> > > advk_pcie_wr_conf() is called for PCI bus which doesn't belong to emulated
> > > root bridge, the aardvark driver throws the following error message:
> > >
> > > advk-pcie d0070000.pcie: config read/write timed out
> > >
> > > Obviously accessing PCIe registers of disconnected card is not possible.
> > >
> > > Extend check in advk_pcie_valid_device() function for validating
> > > availability of PCIe bus. If PCIe link is down, then the device is marked
> > > as Not Found and the driver does not try to access these registers.
> > >
> > > Signed-off-by: Pali Rohár <pali@kernel.org>
> > > ---
> > > drivers/pci/controller/pci-aardvark.c | 3 +++
> > > 1 file changed, 3 insertions(+)
> > >
> > > diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
> > > index 90ff291c24f0..53a4cfd7d377 100644
> > > --- a/drivers/pci/controller/pci-aardvark.c
> > > +++ b/drivers/pci/controller/pci-aardvark.c
> > > @@ -644,6 +644,9 @@ static bool advk_pcie_valid_device(struct advk_pcie *pcie, struct pci_bus *bus,
> > > if ((bus->number == pcie->root_bus_nr) && PCI_SLOT(devfn) != 0)
> > > return false;
> > >
> > > + if (bus->number != pcie->root_bus_nr && !advk_pcie_link_up(pcie))
> > > + return false;
> >
> > I don't think this is the right fix. This makes it racy because the
> > link may go down after we call advk_pcie_valid_device() but before we
> > perform the config read.
>
> Yes, it is racy, but I do not think it cause problems. Trying to read
> PCIe registers when device is not connected cause just those timeouts,
> printing error message and increased delay in advk_pcie_wait_pio() due
> to polling loop. This patch reduce unnecessary access to PCIe registers
> when advk_pcie_wait_pio() polling just fail.
>
> I think it is a good idea to not call blocking advk_pcie_wait_pio() when
> it is not needed. We could have faster enumeration of PCIe buses when
> card is not connected.

Maybe advk_pcie_check_pio_status() and advk_pcie_wait_pio() could be
combined so we could get the correct error status as soon as it's
available, without waiting for a timeout?

In any event, the "return PCIBIOS_SET_FAILED" needs to be fixed. Most
callers of config read do not check for failure, but most of the ones
that do, check for "val == ~0". Only a few check for a status of
other than PCIBIOS_SUCCESSFUL.

> > I have no objection to removing the "config read/write timed out"
> > message. The "return PCIBIOS_SET_FAILED" in the read case probably
> > should be augmented by setting "*val = 0xffffffff".
> >
> > > return true;
> > > }
> > >
> > > --
> > > 2.20.1
> > >

\
 
 \ /
  Last update: 2020-05-28 18:51    [W:0.071 / U:0.676 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site