lkml.org 
[lkml]   [2020]   [May]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH net-next 1/2] net: hns3: adds support for dynamic VLAN mode
On Thu, 21 May 2020 09:33:14 +0800 tanhuazhong wrote:
> On 2020/5/21 5:06, Jakub Kicinski wrote:
> > On Wed, 20 May 2020 09:20:12 +0800 Huazhong Tan wrote:
> >> From: GuoJia Liao <liaoguojia@huawei.com>
> >>
> >> There is a scenario which needs vNICs enable the VLAN filter
> >> in access port, while disable the VLAN filter in trunk port.
> >> Access port and trunk port can switch according to the user's
> >> configuration.
> >>
> >> This patch adds support for the dynamic VLAN mode. then the
> >> HNS3 driver can support two VLAN modes: default VLAN mode and
> >> dynamic VLAN mode. User can switch the mode through the
> >> configuration file.
> >
> > What configuration file? Sounds like you're reimplementing trusted
> > VFs (ndo_set_vf_trust).
> >
>
> Hi, Jakub.
>
> Maybe this configuration file here is a little misleading,
> this VLAN mode is decided by the firmware, the driver will
> query the VLAN mode from firmware during intializing.

And the FW got that configuration from?

> I will modified this description in V2. BTW, is there any
> other suggestion about this patch?

The other suggestion was to trusted vf. What's the difference between
trusted VF and "dynamic VLAN mode"?

> >> In default VLAN mode, port based VLAN filter and VF VLAN
> >> filter should always be enabled.
> >>
> >> In dynamic VLAN mode, port based VLAN filter is disabled, and
> >> VF VLAN filter is disabled defaultly, and should be enabled
> >> when there is a non-zero VLAN ID. In addition, VF VLAN filter
> >> is enabled if PVID is enabled for vNIC.
> >>
> >> When enable promisc, VLAN filter should be disabled. When disable
> >> promisc, VLAN filter's status depends on the value of
> >> 'vport->vf_vlan_en', which is used to record the VF VLAN filter
> >> status.
> >>
> >> In default VLAN mode, 'vport->vf_vlan_en' always be 'true', so
> >> VF VLAN filter will set to be enabled after disabling promisc.
> >>
> >> In dynamic VLAN mode, 'vport->vf_vlan_en' lies on whether there
> >> is a non-zero VLAN ID.
> >>
> >> Signed-off-by: GuoJia Liao <liaoguojia@huawei.com>
> >> Signed-off-by: Huazhong Tan <tanhuazhong@huawei.com>

\
 
 \ /
  Last update: 2020-05-21 03:36    [W:0.133 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site