lkml.org 
[lkml]   [2020]   [May]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 2/4] dt-bindings: iio: magnetometer: ak8975: add gpio reset support
Date
Add reset-gpio support.

Without reset's deassertion during ak8975_power_on(), driver's probe fails
on ak8975_who_i_am() while checking for device identity for AK09911 chip.

AK09911 has an active low reset gpio to handle register's reset.
AK09911 datasheed says that, if not used, reset pin should be connected
to VID. This patch emulates this situation.

Signed-off-by: Jonathan Albrieux <jonathan.albrieux@gmail.com>
---
.../devicetree/bindings/iio/magnetometer/ak8975.yaml | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/iio/magnetometer/ak8975.yaml b/Documentation/devicetree/bindings/iio/magnetometer/ak8975.yaml
index 86e3efa693a8..a82c0ff5d098 100644
--- a/Documentation/devicetree/bindings/iio/magnetometer/ak8975.yaml
+++ b/Documentation/devicetree/bindings/iio/magnetometer/ak8975.yaml
@@ -37,6 +37,9 @@ properties:
mount-matrix:
description: an optional 3x3 mounting rotation matrix

+ reset-gpio:
+ description: an optional pin needed for AK09911 to set the reset state
+
required:
- compatible
- reg
@@ -53,6 +56,7 @@ examples:
reg = <0x0c>;
gpios = <&gpj0 7 0>;
vdd-supply = <&ldo_3v3_gnss>;
+ reset-gpio = <&msmgpio 111 1>;
mount-matrix = "-0.984807753012208", /* x0 */
"0", /* y0 */
"-0.173648177666930", /* z0 */
--
2.17.1
\
 
 \ /
  Last update: 2020-05-19 14:45    [W:0.859 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site