lkml.org 
[lkml]   [2020]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 4/6] media: ov5647: Use gpiod_set_value_cansleep
Date
From: Dave Stevenson <dave.stevenson@raspberrypi.org>

All calls to the gpio library are in contexts that can sleep,
therefore there is no issue with having those GPIOs controlled
by controllers which require sleeping (eg I2C GPIO expanders).

Switch to using gpiod_set_value_cansleep instead of gpiod_set_value
to avoid triggering the warning in gpiolib should the GPIO
controller need to sleep.

Signed-off-by: Dave Stevenson <dave.stevenson@raspberrypi.org>
Signed-off-by: Roman Kovalivskyi <roman.kovalivskyi@globallogic.com>
---
drivers/media/i2c/ov5647.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/media/i2c/ov5647.c b/drivers/media/i2c/ov5647.c
index 10f35c637f91..7600b4844f16 100644
--- a/drivers/media/i2c/ov5647.c
+++ b/drivers/media/i2c/ov5647.c
@@ -378,7 +378,7 @@ static int ov5647_sensor_power(struct v4l2_subdev *sd, int on)
dev_dbg(&client->dev, "OV5647 power on\n");

if (ov5647->pwdn) {
- gpiod_set_value(ov5647->pwdn, 0);
+ gpiod_set_value_cansleep(ov5647->pwdn, 0);
msleep_range(PWDN_ACTIVE_DELAY_MS);
}

@@ -420,7 +420,7 @@ static int ov5647_sensor_power(struct v4l2_subdev *sd, int on)

clk_disable_unprepare(ov5647->xclk);

- gpiod_set_value(ov5647->pwdn, 1);
+ gpiod_set_value_cansleep(ov5647->pwdn, 1);
}

/* Update the power count. */
@@ -661,13 +661,13 @@ static int ov5647_probe(struct i2c_client *client)
goto mutex_remove;

if (sensor->pwdn) {
- gpiod_set_value(sensor->pwdn, 0);
+ gpiod_set_value_cansleep(sensor->pwdn, 0);
msleep_range(PWDN_ACTIVE_DELAY_MS);
}

ret = ov5647_detect(sd);

- gpiod_set_value(sensor->pwdn, 1);
+ gpiod_set_value_cansleep(sensor->pwdn, 1);

if (ret < 0)
goto error;
--
2.17.1
\
 
 \ /
  Last update: 2020-05-19 03:17    [W:0.064 / U:1.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site