lkml.org 
[lkml]   [2020]   [May]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH V1 0/3] Internal voltage control for qcom SDHC
Date
On qcom SD host controllers voltage switching be done after the HW
is ready for it. The HW informs its readiness through power irq.
The voltage switching should happen only then.

So added support to register voltage regulators from the msm driver
and use them.

This patchset was posted long back but not actively pursued
https://lore.kernel.org/linux-arm-msm/1539004739-32060-1-git-send-email-vbadigan@codeaurora.org/
So posting it as fresh patchset.

Veerabhadrarao Badiganti (1):
dt-bindings: mmc: Supply max load for mmc supplies

Vijay Viswanath (2):
mmc: sdhci-msm: Use internal voltage control
mmc: sdhci: Allow platform controlled voltage switching

.../devicetree/bindings/mmc/mmc-controller.yaml | 16 ++
drivers/mmc/host/sdhci-msm.c | 215 ++++++++++++++++++++-
drivers/mmc/host/sdhci.c | 32 +--
drivers/mmc/host/sdhci.h | 1 +
4 files changed, 243 insertions(+), 21 deletions(-)

--
Qualcomm India Private Limited, on behalf of Qualcomm Innovation Center, Inc., is a member of Code Aurora Forum, a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2020-05-15 13:20    [W:0.648 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site