lkml.org 
[lkml]   [2020]   [Apr]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] ARM: dts: enable WLAN for Mecer Xtreme Mini S6
Date
The Mecer Xtreme Mini S6 features a wireless module, based on a
Realtek 8723BS, which provides WLAN and Bluetooth connectivity via
SDIO and UART interfaces respectively.

Define a simple MMC power sequence that declares the GPIO pins
connected to the module's WLAN Disable and Bluetooth Disable pins
as active low reset signals, because both signals must be deasserted
for WLAN radio operation.

Configure the host's SDIO interface for High Speed mode with 1.8v
I/O signalling and IRQ detection over a 4-bit wide bus.

Signed-off-by: Justin Swartz <justin.swartz@risingedge.co.za>
---
Changes in v2:
- Remove unused disable-wp and deprecated num-slots attributes
from &sdio, as suggested by Johan Jonker.

arch/arm/boot/dts/rk3229-xms6.dts | 16 ++++++++++++++++
1 file changed, 16 insertions(+)

diff --git a/arch/arm/boot/dts/rk3229-xms6.dts b/arch/arm/boot/dts/rk3229-xms6.dts
index 679fc2b00..6890af0b7 100644
--- a/arch/arm/boot/dts/rk3229-xms6.dts
+++ b/arch/arm/boot/dts/rk3229-xms6.dts
@@ -39,6 +39,12 @@
};
};

+ sdio_pwrseq: sdio-pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&gpio2 26 GPIO_ACTIVE_LOW>,
+ <&gpio2 29 GPIO_ACTIVE_LOW>;
+ };
+
vcc_host: vcc-host-regulator {
compatible = "regulator-fixed";
enable-active-high;
@@ -202,6 +208,16 @@
status = "okay";
};

+&sdio {
+ bus-width = <4>;
+ cap-sd-highspeed;
+ cap-sdio-irq;
+ mmc-pwrseq = <&sdio_pwrseq>;
+ non-removable;
+ vqmmc-supply = <&vccio_1v8>;
+ status = "okay";
+};
+
&sdmmc {
cap-mmc-highspeed;
disable-wp;
--
2.11.0
\
 
 \ /
  Last update: 2020-04-06 15:55    [W:0.066 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site