Messages in this thread | | | Date | Sun, 26 Apr 2020 09:51:41 +0200 | From | Greg KH <> | Subject | Re: [PATCH v2 1/2] Changes in w1_therm.c and adding w1_therm.h |
| |
On Sat, Apr 25, 2020 at 05:31:41PM +0200, Akira Shimahara wrote: > From: Akira SHIMAHARA <akira215corp@gmail.com> > > Patch for enhacement of w1_therm module. Added features : > - Bulk read : send one command for all the slaves > on the bus to trigger temperature conversion > - Optimized conversion time regarding to device resolution > - Dedicated sysfs entry for powering read, > resolution set/get, eeprom save/restore > - Alarms settings and reading > - Code optimization to mitigate bus traffic > (devices information are stored to avoid > interrogating each device every-time) > > Following sysfs entry are added : > - temperature (RO) : return the temperature in 1/1000° > - ext_power (RO) : return the power status of the device > - resolution (RW) : get or set the device resolution (supported devices) > - eeprom (WO) :trigger a save or restore to/from device EEPROM > - alarms (RW) : read or write TH and TL in the device RAM > - therm_bulk_read (RW) : Attribute at master level to trigger > bulk read and to survey the progress of devices conversions > - w1_slave has been kept for compatibility > > Main motivation was to improve temperature reading speed, which depend > on resolution settings of devices. The module store the powwer status and > the resolution of each device so that during reading operation, no > transaction is required on the bus, which improve speed. > The hardware status is checked as soon as a new device is detected, > when a user change occurred, or when the corresponding sys file is > accessed by user. > > The bulk read allow to trigger convserion of all devices on the bus at > the same time. It will apply a strong pull up on the line if at least > one device required it. The duration of the pull up is the max time > required by a device on the line. > > Please let me know any feedback you have on this patch. > > Thanks ahead, > > Signed-off-by: Akira Shimahara <akira215corp@gmail.com> > --- > Changes in v2: > - Adding documentation in Documentatin/ABI/testing/sysfs-driver-w1_therm > - Updating existing documentation in Documentation/w1/slaves/w1_therm.rst > > drivers/w1/slaves/w1_therm.c | 1406 ++++++++++++++++++++++++++-------- > drivers/w1/slaves/w1_therm.h | 386 ++++++++++ > 2 files changed, 1470 insertions(+), 322 deletions(-) > create mode 100644 drivers/w1/slaves/w1_therm.h
No documentation files are added here :(
| |