lkml.org 
[lkml]   [2020]   [Apr]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v4 05/16] mtd: spi-nor: default to address width of 3 for configurable widths
From
Date
On 2020/4/25 2:43, Pratyush Yadav wrote:
> JESD216D.01 says that when the address width can be 3 or 4, it defaults
> to 3 and enters 4-byte mode when given the appropriate command. So, when
> we see a configurable width, default to 3 and let flash that default to
> 4 change it in a post-bfpt fixup.
>
> This fixes SMPT parsing for flashes with configurable address width. If
> the SMPT descriptor advertises variable address width, we use
> nor->addr_width as the address width. But since it was not set to any
> value from the SFDP table, the read command uses an address width of 0,
> resulting in an incorrect read being issued.
>
> Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
> ---
> drivers/mtd/spi-nor/sfdp.c | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/drivers/mtd/spi-nor/sfdp.c b/drivers/mtd/spi-nor/sfdp.c
> index f917631c8110..5cecc4ba2141 100644
> --- a/drivers/mtd/spi-nor/sfdp.c
> +++ b/drivers/mtd/spi-nor/sfdp.c
> @@ -460,6 +460,7 @@ static int spi_nor_parse_bfpt(struct spi_nor *nor,
> /* Number of address bytes. */
> switch (bfpt.dwords[BFPT_DWORD(1)] & BFPT_DWORD1_ADDRESS_BYTES_MASK) {
> case BFPT_DWORD1_ADDRESS_BYTES_3_ONLY:
> + case BFPT_DWORD1_ADDRESS_BYTES_3_OR_4:
> nor->addr_width = 3;
> break;

Should we also assign address width to 3 in default condition. At least we should not
leave it uninitialized here.

Regards,
Yicong


>

\
 
 \ /
  Last update: 2020-04-26 05:54    [W:0.335 / U:0.372 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site