lkml.org 
[lkml]   [2020]   [Apr]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v5 3/4] blk-mq: Rerun dispatching in the case of budget contention
Date
If ever a thread running blk-mq code tries to get budget and fails it
immediately stops doing work and assumes that whenever budget is freed
up that queues will be kicked and whatever work the thread was trying
to do will be tried again.

One path where budget is freed and queues are kicked in the normal
case can be seen in scsi_finish_command(). Specifically:
- scsi_finish_command()
- scsi_device_unbusy()
- # Decrement "device_busy", AKA release budget
- scsi_io_completion()
- scsi_end_request()
- blk_mq_run_hw_queues()

The above is all well and good. The problem comes up when a thread
claims the budget but then releases it without actually dispatching
any work. Since we didn't schedule any work we'll never run the path
of finishing work / kicking the queues.

This isn't often actually a problem which is why this issue has
existed for a while and nobody noticed. Specifically we only get into
this situation when we unexpectedly found that we weren't going to do
any work. Code that later receives new work kicks the queues. All
good, right?

The problem shows up, however, if timing is just wrong and we hit a
race. To see this race let's think about the case where we only have
a budget of 1 (only one thread can hold budget). Now imagine that a
thread got budget and then decided not to dispatch work. It's about
to call put_budget() but then the thread gets context switched out for
a long, long time. While in this state, any and all kicks of the
queue (like the when we received new work) will be no-ops because
nobody can get budget. Finally the thread holding budget gets to run
again and returns. All the normal kicks will have been no-ops and we
have an I/O stall.

As you can see from the above, you need just the right timing to see
the race. To start with, the only case it happens if we thought we
had work, actually managed to get the budget, but then actually didn't
have work. That's pretty rare to start with. Even then, there's
usually a very small amount of time between realizing that there's no
work and putting the budget. During this small amount of time new
work has to come in and the queue kick has to make it all the way to
trying to get the budget and fail. It's pretty unlikely.

One case where this could have failed is illustrated by an example of
threads running blk_mq_do_dispatch_sched():

* Threads A and B both run has_work() at the same time with the same
"hctx". Imagine has_work() is exact. There's no lock, so it's OK
if Thread A and B both get back true.
* Thread B gets interrupted for a long time right after it decides
that there is work. Maybe its CPU gets an interrupt and the
interrupt handler is slow.
* Thread A runs, get budget, dispatches work.
* Thread A's work finishes and budget is released.
* Thread B finally runs again and gets budget.
* Since Thread A already took care of the work and no new work has
come in, Thread B will get NULL from dispatch_request(). I believe
this is specifically why dispatch_request() is allowed to return
NULL in the first place if has_work() must be exact.
* Thread B will now be holding the budget and is about to call
put_budget(), but hasn't called it yet.
* Thread B gets interrupted for a long time (again). Dang interrupts.
* Now Thread C (maybe with a different "hctx" but the same queue)
comes along and runs blk_mq_do_dispatch_sched().
* Thread C won't do anything because it can't get budget.
* Finally Thread B will run again and put the budget without kicking
any queues.

Even though the example above is with blk_mq_do_dispatch_sched() I
believe the race is possible any time someone is holding budget but
doesn't do work.

Unfortunately, the unlikely has become more likely if you happen to be
using the BFQ I/O scheduler. BFQ, by design, sometimes returns "true"
for has_work() but then NULL for dispatch_request() and stays in this
state for a while (currently up to 9 ms). Suddenly you only need one
race to hit, not two races in a row. With my current setup this is
easy to reproduce in reboot tests and traces have actually shown that
we hit a race similar to the one described above.

Note that we only need to fix blk_mq_do_dispatch_sched() and
blk_mq_do_dispatch_ctx() and not the other places that put budget. In
other cases we know that we have work to do on at least one "hctx" and
code already exists to kick that "hctx"'s queue. When that work
finally finishes all the queues will be kicked using the normal flow.

One last note is that (at least in the SCSI case) budget is shared by
all "hctx"s that have the same queue. Thus we need to make sure to
kick the whole queue, not just re-run dispatching on a single "hctx".

Signed-off-by: Douglas Anderson <dianders@chromium.org>
Reviewed-by: Ming Lei <ming.lei@redhat.com>
---

Changes in v5: None
Changes in v4:
- Only kick in blk_mq_do_dispatch_ctx() / blk_mq_do_dispatch_sched().

Changes in v3:
- Always kick when putting the budget.
- Delay blk_mq_do_dispatch_sched() kick by 3 ms for inexact has_work().
- Totally rewrote commit message.

Changes in v2:
- Replace ("scsi: core: Fix stall...") w/ ("blk-mq: Rerun dispatch...")

block/blk-mq-sched.c | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)

diff --git a/block/blk-mq-sched.c b/block/blk-mq-sched.c
index 74cedea56034..eca81bd4010c 100644
--- a/block/blk-mq-sched.c
+++ b/block/blk-mq-sched.c
@@ -80,6 +80,8 @@ void blk_mq_sched_restart(struct blk_mq_hw_ctx *hctx)
blk_mq_run_hw_queue(hctx, true);
}

+#define BLK_MQ_BUDGET_DELAY 3 /* ms units */
+
/*
* Only SCSI implements .get_budget and .put_budget, and SCSI restarts
* its queue by itself in its completion handler, so we don't need to
@@ -103,6 +105,14 @@ static void blk_mq_do_dispatch_sched(struct blk_mq_hw_ctx *hctx)
rq = e->type->ops.dispatch_request(hctx);
if (!rq) {
blk_mq_put_dispatch_budget(hctx);
+ /*
+ * We're releasing without dispatching. Holding the
+ * budget could have blocked any "hctx"s with the
+ * same queue and if we didn't dispatch then there's
+ * no guarantee anyone will kick the queue. Kick it
+ * ourselves.
+ */
+ blk_mq_delay_run_hw_queues(q, BLK_MQ_BUDGET_DELAY);
break;
}

@@ -149,6 +159,14 @@ static void blk_mq_do_dispatch_ctx(struct blk_mq_hw_ctx *hctx)
rq = blk_mq_dequeue_from_ctx(hctx, ctx);
if (!rq) {
blk_mq_put_dispatch_budget(hctx);
+ /*
+ * We're releasing without dispatching. Holding the
+ * budget could have blocked any "hctx"s with the
+ * same queue and if we didn't dispatch then there's
+ * no guarantee anyone will kick the queue. Kick it
+ * ourselves.
+ */
+ blk_mq_delay_run_hw_queues(q, BLK_MQ_BUDGET_DELAY);
break;
}

--
2.26.1.301.g55bc3eb7cb9-goog
\
 
 \ /
  Last update: 2020-04-20 18:26    [W:0.598 / U:0.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site