Messages in this thread | | | Subject | Re: [PATCH] loop: Call loop_config_discard() only after new config is applied. | From | Bart Van Assche <> | Date | Sat, 18 Apr 2020 08:46:10 -0700 |
| |
On 2020-03-31 04:41, Martijn Coenen wrote: > loop_set_status() calls loop_config_discard() to configure discard for > the loop device; however, the discard configuration depends on whether > the loop device uses encryption, and when we call it the encryption > configuration has not been updated yet. Move the call down so we apply > the correct discard configuration based on the new configuration.
Reviewed-by: Bart Van Assche <bvanassche@acm.org>
| |