lkml.org 
[lkml]   [2020]   [Apr]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] loop: Call loop_config_discard() only after new config is applied.
From
Date
On 3/31/20 7:41 PM, Martijn Coenen wrote:
> loop_set_status() calls loop_config_discard() to configure discard for
> the loop device; however, the discard configuration depends on whether
> the loop device uses encryption, and when we call it the encryption
> configuration has not been updated yet. Move the call down so we apply
> the correct discard configuration based on the new configuration.
>
> Signed-off-by: Martijn Coenen <maco@android.com>

Looks fine to me.
Reviewed-by: Bob Liu <bob.liu@oracle.com>

> ---
> drivers/block/loop.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/block/loop.c b/drivers/block/loop.c
> index 739b372a5112..7c9dcb6007a6 100644
> --- a/drivers/block/loop.c
> +++ b/drivers/block/loop.c
> @@ -1312,8 +1312,6 @@ loop_set_status(struct loop_device *lo, const struct loop_info64 *info)
> }
> }
>
> - loop_config_discard(lo);
> -
> memcpy(lo->lo_file_name, info->lo_file_name, LO_NAME_SIZE);
> memcpy(lo->lo_crypt_name, info->lo_crypt_name, LO_NAME_SIZE);
> lo->lo_file_name[LO_NAME_SIZE-1] = 0;
> @@ -1337,6 +1335,8 @@ loop_set_status(struct loop_device *lo, const struct loop_info64 *info)
> lo->lo_key_owner = uid;
> }
>
> + loop_config_discard(lo);
> +
> /* update dio if lo_offset or transfer is changed */
> __loop_update_dio(lo, lo->use_dio);
>
>

\
 
 \ /
  Last update: 2020-04-17 02:21    [W:0.074 / U:0.480 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site