lkml.org 
[lkml]   [2020]   [Mar]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH 2/3] dt-bindings: remoteproc: qcom: Add modem-firmware bindings
    Date
    Introduce modem-firmware binding to allow Q6 modem to boot on platforms
    which do not have trustZone.

    Signed-off-by: Sibi Sankar <sibis@codeaurora.org>
    ---
    Documentation/devicetree/bindings/remoteproc/qcom,q6v5.txt | 4 ++++
    1 file changed, 4 insertions(+)

    diff --git a/Documentation/devicetree/bindings/remoteproc/qcom,q6v5.txt b/Documentation/devicetree/bindings/remoteproc/qcom,q6v5.txt
    index 88dfa3fc15f78..b1715bc90fb05 100644
    --- a/Documentation/devicetree/bindings/remoteproc/qcom,q6v5.txt
    +++ b/Documentation/devicetree/bindings/remoteproc/qcom,q6v5.txt
    @@ -198,6 +198,10 @@ The Hexagon node may also have an subnode named either "smd-edge" or
    related to the Hexagon. See ../soc/qcom/qcom,smd.txt and
    ../soc/qcom/qcom,glink.txt for details on how to describe these.

    +The Hexagon node must contain a subnode named "modem-firmware" on
    +platforms which do not have TrustZone. The sub-node should have the
    +iommu property as described in ../iommu/iommu.txt.
    +
    = EXAMPLE
    The following example describes the resources needed to boot control the
    Hexagon, as it is found on MSM8974 boards.
    --
    The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
    a Linux Foundation Collaborative Project
    \
     
     \ /
      Last update: 2020-03-09 19:24    [W:3.268 / U:0.680 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site