lkml.org 
[lkml]   [2020]   [Mar]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v12 2/6] dt-bindings: display: mediatek: control dpi pins mode to avoid leakage
On Tue, Mar 03, 2020 at 01:27:18PM +0800, Jitao Shi wrote:
> Add property "pinctrl-names" to swap pin mode between gpio and dpi mode. Set
> the dpi pins to gpio mode and output-low to avoid leakage current when dpi
> disabled.
>
> Signed-off-by: Jitao Shi <jitao.shi@mediatek.com>
> ---
> .../devicetree/bindings/display/mediatek/mediatek,dpi.txt | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> index 58914cf681b8..77ca32a32399 100644
> --- a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> +++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> @@ -17,6 +17,10 @@ Required properties:
> Documentation/devicetree/bindings/graph.txt. This port should be connected
> to the input port of an attached HDMI or LVDS encoder chip.
>
> +Optional properties:
> +- pinctrl-names: Contain "gpiomode" and "dpimode".

Doesn't match the example.

> + pinctrl-names see Documentation/devicetree/bindings/pinctrlpinctrl-bindings.txt
> +
> Example:
>
> dpi0: dpi@1401d000 {
> @@ -27,6 +31,9 @@ dpi0: dpi@1401d000 {
> <&mmsys CLK_MM_DPI_ENGINE>,
> <&apmixedsys CLK_APMIXED_TVDPLL>;
> clock-names = "pixel", "engine", "pll";
> + pinctrl-names = "active", "idle";
> + pinctrl-0 = <&dpi_pin_func>;
> + pinctrl-1 = <&dpi_pin_idle>;
>
> port {
> dpi0_out: endpoint {
> --
> 2.21.0

\
 
 \ /
  Last update: 2020-03-04 16:00    [W:0.080 / U:1.944 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site