lkml.org 
[lkml]   [2020]   [Mar]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] docs: networking: net_failover: Fix a few typos
Date
Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net>
---
Documentation/networking/net_failover.rst | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/networking/net_failover.rst b/Documentation/networking/net_failover.rst
index 06c97dcb57ca..e143ab79a960 100644
--- a/Documentation/networking/net_failover.rst
+++ b/Documentation/networking/net_failover.rst
@@ -8,9 +8,9 @@ Overview
========

The net_failover driver provides an automated failover mechanism via APIs
-to create and destroy a failover master netdev and mananges a primary and
+to create and destroy a failover master netdev and manages a primary and
standby slave netdevs that get registered via the generic failover
-infrastructrure.
+infrastructure.

The failover netdev acts a master device and controls 2 slave devices. The
original paravirtual interface is registered as 'standby' slave netdev and
@@ -29,7 +29,7 @@ virtio-net accelerated datapath: STANDBY mode
=============================================

net_failover enables hypervisor controlled accelerated datapath to virtio-net
-enabled VMs in a transparent manner with no/minimal guest userspace chanages.
+enabled VMs in a transparent manner with no/minimal guest userspace changes.

To support this, the hypervisor needs to enable VIRTIO_NET_F_STANDBY
feature on the virtio-net interface and assign the same MAC address to both
--
2.20.1
\
 
 \ /
  Last update: 2020-03-03 21:24    [W:1.587 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site