Messages in this thread | | | From | Linus Walleij <> | Date | Sat, 28 Mar 2020 00:33:42 +0100 | Subject | Re: [PATCH v3] pinctrl: qcom: use scm_call to route GPIO irq to Apps |
| |
On Fri, Mar 27, 2020 at 11:32 PM Ansuel Smith <ansuelsmth@gmail.com> wrote:
> From: Ajay Kishore <akisho@codeaurora.org> > > For IPQ806x targets, TZ protects the registers that are used to > configure the routing of interrupts to a target processor. > To resolve this, this patch uses scm call to route GPIO interrupts > to application processor. Also the scm call interface is changed. > > Signed-off-by: Ajay Kishore <akisho@codeaurora.org> > Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> > --- > v3: > * Rename route_to_apps to intr_target_use_scm > * Follow standard design and rename base_reg to phys_base > * Add additional comments in route interrupts condition
Patch applied with Björn's review tag.
Yours, Linus Walleij
| |