lkml.org 
[lkml]   [2020]   [Mar]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/2] scsi: ufs-mediatek: add error recovery for suspend and resume
Date
Once fail happens during suspend and resume flow if the desired low
power link state is H8, link recovery is required for MediaTek UFS
controller.

For resume flow, since power and clocks are already enabled before
invoking vendor's resume callback, simply using ufshcd_link_recovery()
inside callback is fine.

For suspend flow, the device power enters low power mode or is disabled
before suspend callback, thus ufshcd_link_recovery() can not be directly
used in callback. To leverage host reset flow during ufshcd_suspend(),
set link as off state enforcedly to let ufshcd_host_reset_and_restore()
be executed by ufshcd_suspend().

Signed-off-by: Stanley Chu <stanley.chu@mediatek.com>
---
drivers/scsi/ufs/ufs-mediatek.c | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-mediatek.c b/drivers/scsi/ufs/ufs-mediatek.c
index 3b0e575d7460..2384e35ac85f 100644
--- a/drivers/scsi/ufs/ufs-mediatek.c
+++ b/drivers/scsi/ufs/ufs-mediatek.c
@@ -486,8 +486,15 @@ static int ufs_mtk_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)

if (ufshcd_is_link_hibern8(hba)) {
err = ufs_mtk_link_set_lpm(hba);
- if (err)
+ if (err) {
+ /*
+ * Set link as off state enforcedly to trigger
+ * ufshcd_host_reset_and_restore() in ufshcd_suspend()
+ * for completed host reset.
+ */
+ ufshcd_set_link_off(hba);
return -EAGAIN;
+ }
}

if (!ufshcd_is_link_active(hba))
@@ -506,8 +513,10 @@ static int ufs_mtk_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)

if (ufshcd_is_link_hibern8(hba)) {
err = ufs_mtk_link_set_hpm(hba);
- if (err)
+ if (err) {
+ err = ufshcd_link_recovery(hba);
return err;
+ }
}

return 0;
--
2.18.0
\
 
 \ /
  Last update: 2020-03-26 16:08    [W:0.074 / U:5.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site