lkml.org 
[lkml]   [2020]   [Mar]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] ARM: dts: apalis-imx6qdl: use rgmii-id instead of rgmii
Date
Until now a PHY-fixup in mach-imx set our rgmii timing correctly. For
the PHY KSZ9131 there is no PHY-fixup in mach-imx. To support this PHY
too, use rgmii-id.
For the now used KSZ9031 nothing will change, as rgmii-id is only
implemented and supported by the KSZ9131.

Signed-off-by: Philippe Schenker <philippe.schenker@toradex.com>

---

arch/arm/boot/dts/imx6qdl-apalis.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
index 1b5bc6b5e806..347a5edc6927 100644
--- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi
@@ -180,7 +180,7 @@ &ecspi2 {
&fec {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_enet>;
- phy-mode = "rgmii";
+ phy-mode = "rgmii-id";
phy-handle = <&ethphy>;
phy-reset-duration = <10>;
phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
--
2.26.0
\
 
 \ /
  Last update: 2020-03-25 16:04    [W:0.050 / U:22.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site