[lkml]   [2020]   [Mar]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH net 3/3] arm64: dts: ls1046ardb: set RGMII interfaces to RGMII_ID mode
The correct setting for the RGMII ports on LS1046ARDB is to
enable delay on both Rx and Tx so the interface mode used must

Since commit 1b3047b5208a80 ("net: phy: realtek: add support for
configuring the RX delay on RTL8211F") the Realtek 8211F PHY driver
has control over the RGMII RX delay and it is disabling it for
RGMII_TXID. The LS1046ARDB uses two such PHYs in RGMII_ID mode but
in the device tree the mode was described as "rgmii".

Changing the phy-connection-type to "rgmii-id" to address the issue.

Fixes: 3fa395d2c48a ("arm64: dts: add LS1046A DPAA FMan nodes")
Signed-off-by: Madalin Bucur <>
arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
index dbc23d6cd3b4..d53ccc56bb63 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts
@@ -131,12 +131,12 @@
&fman0 {
ethernet@e4000 {
phy-handle = <&rgmii_phy1>;
- phy-connection-type = "rgmii";
+ phy-connection-type = "rgmii-id";

ethernet@e6000 {
phy-handle = <&rgmii_phy2>;
- phy-connection-type = "rgmii";
+ phy-connection-type = "rgmii-id";

ethernet@e8000 {
 \ /
  Last update: 2020-03-13 13:05    [W:0.081 / U:1.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site