lkml.org 
[lkml]   [2020]   [Mar]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 1/2] sdhci: tegra: Implement Tegra specific set_timeout callback
-trimmed cc list

On Thu, 12 Mar 2020 at 00:51, Sowjanya Komatineni
<skomatineni@nvidia.com> wrote:
>
> Tegra host supports HW busy detection and timeouts based on the
> count programmed in SDHCI_TIMEOUT_CONTROL register and max busy
> timeout it supports is 11s in finite busy wait mode.
>
> Some operations like SLEEP_AWAKE, ERASE and flush cache through
> SWITCH commands take longer than 11s and Tegra host supports
> infinite HW busy wait mode where HW waits forever till the card
> is busy without HW timeout.
>
> This patch implements Tegra specific set_timeout sdhci_ops to allow
> switching between finite and infinite HW busy detection wait modes
> based on the device command expected operation time.
>
> Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com>

Applied for next, thanks!

We should probably tag this for stable as well, don't you think?

Kind regards
Uffe



> ---
> drivers/mmc/host/sdhci-tegra.c | 31 +++++++++++++++++++++++++++++++
> 1 file changed, 31 insertions(+)
>
> diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c
> index a25c3a4..fa8f6a4 100644
> --- a/drivers/mmc/host/sdhci-tegra.c
> +++ b/drivers/mmc/host/sdhci-tegra.c
> @@ -45,6 +45,7 @@
> #define SDHCI_TEGRA_CAP_OVERRIDES_DQS_TRIM_SHIFT 8
>
> #define SDHCI_TEGRA_VENDOR_MISC_CTRL 0x120
> +#define SDHCI_MISC_CTRL_ERASE_TIMEOUT_LIMIT BIT(0)
> #define SDHCI_MISC_CTRL_ENABLE_SDR104 0x8
> #define SDHCI_MISC_CTRL_ENABLE_SDR50 0x10
> #define SDHCI_MISC_CTRL_ENABLE_SDHCI_SPEC_300 0x20
> @@ -1227,6 +1228,34 @@ static u32 sdhci_tegra_cqhci_irq(struct sdhci_host *host, u32 intmask)
> return 0;
> }
>
> +static void tegra_sdhci_set_timeout(struct sdhci_host *host,
> + struct mmc_command *cmd)
> +{
> + u32 val;
> +
> + /*
> + * HW busy detection timeout is based on programmed data timeout
> + * counter and maximum supported timeout is 11s which may not be
> + * enough for long operations like cache flush, sleep awake, erase.
> + *
> + * ERASE_TIMEOUT_LIMIT bit of VENDOR_MISC_CTRL register allows
> + * host controller to wait for busy state until the card is busy
> + * without HW timeout.
> + *
> + * So, use infinite busy wait mode for operations that may take
> + * more than maximum HW busy timeout of 11s otherwise use finite
> + * busy wait mode.
> + */
> + val = sdhci_readl(host, SDHCI_TEGRA_VENDOR_MISC_CTRL);
> + if (cmd && cmd->busy_timeout >= 11 * HZ)
> + val |= SDHCI_MISC_CTRL_ERASE_TIMEOUT_LIMIT;
> + else
> + val &= ~SDHCI_MISC_CTRL_ERASE_TIMEOUT_LIMIT;
> + sdhci_writel(host, val, SDHCI_TEGRA_VENDOR_MISC_CTRL);
> +
> + __sdhci_set_timeout(host, cmd);
> +}
> +
> static const struct cqhci_host_ops sdhci_tegra_cqhci_ops = {
> .write_l = tegra_cqhci_writel,
> .enable = sdhci_tegra_cqe_enable,
> @@ -1366,6 +1395,7 @@ static const struct sdhci_ops tegra210_sdhci_ops = {
> .set_uhs_signaling = tegra_sdhci_set_uhs_signaling,
> .voltage_switch = tegra_sdhci_voltage_switch,
> .get_max_clock = tegra_sdhci_get_max_clock,
> + .set_timeout = tegra_sdhci_set_timeout,
> };
>
> static const struct sdhci_pltfm_data sdhci_tegra210_pdata = {
> @@ -1403,6 +1433,7 @@ static const struct sdhci_ops tegra186_sdhci_ops = {
> .voltage_switch = tegra_sdhci_voltage_switch,
> .get_max_clock = tegra_sdhci_get_max_clock,
> .irq = sdhci_tegra_cqhci_irq,
> + .set_timeout = tegra_sdhci_set_timeout,
> };
>
> static const struct sdhci_pltfm_data sdhci_tegra186_pdata = {
> --
> 2.7.4
>

\
 
 \ /
  Last update: 2020-03-12 14:09    [W:0.106 / U:2.504 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site