lkml.org 
[lkml]   [2020]   [Feb]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCHv9 00/12] PCI: Recode Mobiveil driver and add PCIe Gen4 driver for NXP Layerscape SoCs
On Mon, Feb 10, 2020 at 03:22:57PM +0000, Russell King - ARM Linux admin wrote:
> On Mon, Feb 10, 2020 at 04:12:30PM +0100, Olof Johansson wrote:
> > On Thu, Feb 6, 2020 at 11:57 AM Z.q. Hou <zhiqiang.hou@nxp.com> wrote:
> > >
> > > Hi Olof,
> > >
> > > Thanks a lot for your comments!
> > > And sorry for my delay respond!
> >
> > Actually, they apply with only minor conflicts on top of current -next.
> >
> > Bjorn, any chance we can get you to pick these up pretty soon? They
> > enable full use of a promising ARM developer system, the SolidRun
> > HoneyComb, and would be quite valuable for me and others to be able to
> > use with mainline or -next without any additional patches applied --
> > which this patchset achieves.
> >
> > I know there are pending revisions based on feedback. I'll leave it up
> > to you and others to determine if that can be done with incremental
> > patches on top, or if it should be fixed before the initial patchset
> > is applied. But all in all, it's holding up adaption by me and surely
> > others of a very interesting platform -- I'm looking to replace my
> > aging MacchiatoBin with one of these and would need PCIe/NVMe to work
> > before I do.
>
> If you're going to be using NVMe, make sure you use a power-fail safe
> version; I've already had one instance where ext4 failed to mount
> because of a corrupted journal using an XPG SX8200 after the Honeycomb
> Serror'd, and then I powered it down after a few hours before later
> booting it back up.
>
> EXT4-fs (nvme0n1p2): INFO: recovery required on readonly filesystem
> EXT4-fs (nvme0n1p2): write access will be enabled during recovery
> JBD2: journal transaction 80849 on nvme0n1p2-8 is corrupt.
> EXT4-fs (nvme0n1p2): error loading journal

... and last night, I just got more ext4fs errors on the NVMe, without
any unclean power cycles:

[73729.556544] EXT4-fs error (device nvme0n1p2): ext4_lookup:1700: inode #917524: comm rm: iget: checksum invalid
[73729.565354] Aborting journal on device nvme0n1p2-8.
[73729.568995] EXT4-fs (nvme0n1p2): Remounting filesystem read-only
[73729.569077] EXT4-fs error (device nvme0n1p2): ext4_journal_check_start:61: Detected aborted journal
[73729.573741] EXT4-fs error (device nvme0n1p2): ext4_lookup:1700: inode #917524: comm rm: iget: checksum invalid
[73729.593330] EXT4-fs error (device nvme0n1p2): ext4_lookup:1700: inode #917524: comm mv: iget: checksum invalid

The affected file is /var/backups/dpkg.status.6.gz

It was cleanly shut down and powered off on the 22nd February, booted
yesterday morning followed by another reboot a few minutes later.

What worries me is the fact that corruption has happened - and if that
happens to a file rather than an inode, it will likely go unnoticed
for a considerably longer time.

I think I'm getting to the point of deciding NVMe or the LX2160A to be
just too unreliable for serious use. I hadn't noticed any issues when
using the rootfs on the eMMC, so it suggests either the NVMe is
unreliable, or there's a problem with PCIe on this platform (which we
kind of know about with Jon's GPU rendering issues.)

--
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up
According to speedtest.net: 11.9Mbps down 500kbps up

\
 
 \ /
  Last update: 2020-02-29 10:58    [W:0.150 / U:1.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site