lkml.org 
[lkml]   [2020]   [Feb]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] spi: spidev: fix a debug message value
Date
The debug message in spidev_message() can show wrong xfer speed.
It happens if the initial (came from DT) and set with ioctl call spidev
speeds are different (spidev->speed_hz != spi->max_speed_hz) and one
sends a message with ioctl call and the field of speed is uninitialized
(u_tmp->speed_hz == 0).

In this case the kernel shows the spi->max_speed_hz value instead of
correct spidev->speed_hz.
...
set the max speed with an ioctl call:
[ 1227.702714] spidev spi0.0: setup mode 0, 32 bits/w, 20000000 Hz max --> 0
(real speed sets to 20000000Hz)
send a message with an ioctl call:
[ 1227.731801] spidev spi0.0: xfer len 4096 tx 32bits 0 usec 10000000Hz
(debug message shows 10000000Hz that is the original max speed of this
spidev came from DT)
...

Fix the data source for the debug message.

Signed-off-by: Oleksandr Suvorov <oleksandr.suvorov@toradex.com>
---

drivers/spi/spidev.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)

diff --git a/drivers/spi/spidev.c b/drivers/spi/spidev.c
index 2ab6e782f14c..c97e853dbf5c 100644
--- a/drivers/spi/spidev.c
+++ b/drivers/spi/spidev.c
@@ -275,14 +275,14 @@ static int spidev_message(struct spidev_data *spidev,
#ifdef VERBOSE
dev_dbg(&spidev->spi->dev,
" xfer len %u %s%s%s%dbits %u usec %u usec %uHz\n",
- u_tmp->len,
- u_tmp->rx_buf ? "rx " : "",
- u_tmp->tx_buf ? "tx " : "",
- u_tmp->cs_change ? "cs " : "",
- u_tmp->bits_per_word ? : spidev->spi->bits_per_word,
- u_tmp->delay_usecs,
- u_tmp->word_delay_usecs,
- u_tmp->speed_hz ? : spidev->spi->max_speed_hz);
+ k_tmp->len,
+ k_tmp->rx_buf ? "rx " : "",
+ k_tmp->tx_buf ? "tx " : "",
+ k_tmp->cs_change ? "cs " : "",
+ k_tmp->bits_per_word ? : spidev->spi->bits_per_word,
+ k_tmp->delay.value,
+ k_tmp->word_delay.value,
+ k_tmp->speed_hz ? : spidev->spi->max_speed_hz);
#endif
spi_message_add_tail(k_tmp, &msg);
}
--
2.24.1
\
 
 \ /
  Last update: 2020-02-29 17:20    [W:0.079 / U:0.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site