Messages in this thread Patch in this message | | | From | "H. Nikolaus Schaller" <> | Subject | [PATCH v4 1/5] MIPS: DTS: CI20: add DT node for IR sensor | Date | Fri, 28 Feb 2020 19:02:49 +0100 |
| |
From: Alex Smith <alex.smith@imgtec.com>
The infrared sensor on the CI20 board is connected to a GPIO and can be operated by using the gpio-ir-recv driver. Add a DT node for the sensor to allow that driver to be used.
Signed-off-by: Alex Smith <alex.smith@imgtec.com> Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> --- arch/mips/boot/dts/ingenic/ci20.dts | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/arch/mips/boot/dts/ingenic/ci20.dts b/arch/mips/boot/dts/ingenic/ci20.dts index 37b93166bf22..59c104289ece 100644 --- a/arch/mips/boot/dts/ingenic/ci20.dts +++ b/arch/mips/boot/dts/ingenic/ci20.dts @@ -60,6 +60,11 @@ enable-active-high; }; + ir: ir-receiver { + compatible = "gpio-ir-receiver"; + gpios = <&gpe 3 GPIO_ACTIVE_LOW>; + }; + wlan0_power: fixedregulator@1 { compatible = "regulator-fixed"; regulator-name = "wlan0_power"; -- 2.23.0
| |