lkml.org 
[lkml]   [2020]   [Feb]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 15/16] floppy: separate the FDC's base address from its registers
From
Date
> One place in the ARM code used to check if the port was equal to FD_DOR,
> this was changed to testing the register by applying a mask to the port,
> as was already done in the sparc code.
>
> The sparc, m68k and parisc code could now be slightly cleaned up to
> benefit from the macro definitions above instead of the equivalent
> hard-coded values.

Just to note for future ref: the mask (7) can be introduced as define
during future clean up of these magic constants.

>
> Signed-off-by: Willy Tarreau <w@1wt.eu>
> ---
> arch/arm/include/asm/floppy.h | 2 +-
> drivers/block/floppy.c | 9 ++++-----
> include/uapi/linux/fdreg.h | 18 +++++-------------
> 3 files changed, 10 insertions(+), 19 deletions(-)
>
> diff --git a/arch/arm/include/asm/floppy.h b/arch/arm/include/asm/floppy.h
> index c665136..4e3fb71 100644
> --- a/arch/arm/include/asm/floppy.h
> +++ b/arch/arm/include/asm/floppy.h
> @@ -12,7 +12,7 @@
> #define fd_outb(val,port) \
> do { \
> int new_val = (val); \
> - if ((port) == (u32)FD_DOR) { \
> + if ((port) & 7 == FD_DOR) { \
> if (new_val & 0xf0) \
> new_val = (new_val & 0x0c) | \
> floppy_selects[new_val & 3]; \
> diff --git a/drivers/block/floppy.c b/drivers/block/floppy.c
> index 250a451..4e43a7e 100644
> --- a/drivers/block/floppy.c
> +++ b/drivers/block/floppy.c
> @@ -171,7 +171,6 @@ static int print_unex = 1;
> #include <linux/kernel.h>
> #include <linux/timer.h>
> #include <linux/workqueue.h>
> -#define FDPATCHES
> #include <linux/fdreg.h>
> #include <linux/fd.h>
> #include <linux/hdreg.h>
> @@ -594,14 +593,14 @@ static unsigned char fsector_t; /* sector in track */
> static unsigned char in_sector_offset; /* offset within physical sector,
> * expressed in units of 512 bytes */
>
> -static inline unsigned char fdc_inb(int fdc, unsigned long addr)
> +static inline unsigned char fdc_inb(int fdc, int reg)
> {
> - return fd_inb(addr);
> + return fd_inb(fdc_state[fdc].address + reg);
> }
>
> -static inline void fdc_outb(unsigned char value, int fdc, unsigned long addr)
> +static inline void fdc_outb(unsigned char value, int fdc, int reg)
> {
> - fd_outb(value, addr);
> + fd_outb(value, fdc_state[fdc].address + reg);
> }
>
> static inline bool drive_no_geom(int drive)
> diff --git a/include/uapi/linux/fdreg.h b/include/uapi/linux/fdreg.h
> index 5e2981d..1318881 100644
> --- a/include/uapi/linux/fdreg.h
> +++ b/include/uapi/linux/fdreg.h
> @@ -7,26 +7,18 @@
> * Handbook", Sanches and Canton.
> */
>
> -#ifdef FDPATCHES
> -#define FD_IOPORT fdc_state[fdc].address
> -#else
> -/* It would be a lot saner just to force fdc_state[fdc].address to always
> - be set ! FIXME */
> -#define FD_IOPORT 0x3f0

Again, just to note: FD_IOPORT (now removed), FDC1, FDC_BASE are pointing to
the same port 0x3f0 in many cases.
And at least in some cases used directly:
$ fgrep --include='*floppy*' -nrie '0x3f0' .
./arch/mips/include/asm/mach-generic/floppy.h:113: return 0x3f0;
./arch/m68k/include/asm/floppy.h:124: return 0x3f0;
./drivers/block/floppy.c:234:static unsigned short virtual_dma_port = 0x3f0;

> -#endif
> -
> /* Fd controller regs. S&C, about page 340 */
> -#define FD_STATUS (4 + FD_IOPORT )
> -#define FD_DATA (5 + FD_IOPORT )
> +#define FD_STATUS 4
> +#define FD_DATA 5
>
> /* Digital Output Register */
> -#define FD_DOR (2 + FD_IOPORT )
> +#define FD_DOR 2
>
> /* Digital Input Register (read) */
> -#define FD_DIR (7 + FD_IOPORT )
> +#define FD_DIR 7
>
> /* Diskette Control Register (write)*/
> -#define FD_DCR (7 + FD_IOPORT )
> +#define FD_DCR 7
>
> /* Bits of main status register */
> #define STATUS_BUSYMASK 0x0F /* drive busy mask */
>

Denis

\
 
 \ /
  Last update: 2020-02-26 16:37    [W:0.158 / U:2.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site