lkml.org 
[lkml]   [2020]   [Feb]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] spi: Add FSI-attached SPI controller driver
From
Date

On 2/4/20 5:05 AM, Andy Shevchenko wrote:
> On Tue, Feb 4, 2020 at 12:30 AM Eddie James <eajames@linux.ibm.com> wrote:
>> There exists a set of SPI controllers on some POWER processors that may
>> be accessed through the FSI bus. Add a driver to traverse the FSI CFAM
>> engine that can access and drive the SPI controllers. This driver would
>> typically be used by a baseboard management controller (BMC).
>>
>> The SPI controllers operate by means of programming a sequencing engine
>> which automatically manages the usual SPI protocol buses. The driver
>> programs each transfer into the sequencer as various operations
>> specifying the slave chip and shifting data in and out on the lines.
> Some comments left unsettled in v1, thus applicable here.


I think I addressed all of Andy's comments on v1 now, if Andy agreed
about leaving the byte shifting as-is in fsi_spi_data_in/out.


Thanks,

Eddie


>

\
 
 \ /
  Last update: 2020-02-24 19:54    [W:0.078 / U:1.624 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site