lkml.org 
[lkml]   [2020]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v2 00/12] MIPS: Fixes and improvements for CI20 board (JZ4780)
Date
V2:
* dropped "net: davicom: dm9000: allow to pass MAC address through mac_addr module parameter"
from this series because it goes through the netdev tree
(suggested by Andrew Lunn <andrew@lunn.ch>)
* added a "fixes:" for "MIPS: DTS: CI20: fix PMU definitions for ACT8600"
and "MIPS: DTS: CI20: fix interrupt for pcf8563 RTC"
(suggested by Andreas Kemnade <andreas@kemnade.info>)
* "i2c: jz4780: silence log flood on txabrt" dropped because it is
replaced by a new version in v5.6 by Wolfram Sang <wsa@the-dreams.de>

PATCH V1 2020-02-11 22:41:43:
This patch set provides several improvements for the CI20 board:

* suppress warnings from i2c if device is not responding
* make ingenic-drm found through DT
* allow davicom dm9000 ethernet controller to use MAC address provided by U-Boot
* fix #include in jz4780.dtsi
* configure for loadable kernel modules
* add DTS for IR sensor and SW1 button
* configure so that LEDs, IR sensor, SW1 button have drivers
* fix DTS for ACT8600 PMU and configure driver
* fix interrupt of nxp,pcf8563

There is another patch set in our queue to add HDMI support on top of this work.

Signed-off-by: Paul Boddie <paul@boddie.org.uk>
Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>


Alex Smith (1):
MIPS: DTS: CI20: add DT node for IR sensor

H. Nikolaus Schaller (11):
drm: ingenic-drm: add MODULE_DEVICE_TABLE
MIPS: DTS: jz4780: add #includes for irq.h and gpio.h
MIPS: CI20: defconfig: configure for supporting modules
MIPS: CI20: defconfig: compile leds-gpio driver into the kernel and
configure for LED triggers
MIPS: DTS: CI20: fix PMU definitions for ACT8600
MIPS: CI20: defconfig: configure CONFIG_REGULATOR_ACT8865 for PMU
MIPS: DTS: CI20: give eth0_power a defined voltage.
MIPS: CI20: defconfig: compile gpio-ir driver
MIPS: DTS: CI20: add DT node for SW1 as Enter button
MIPS: CI20: defconfig: configure for CONFIG_KEYBOARD_GPIO=m
MIPS: DTS: CI20: fix interrupt for pcf8563 RTC

arch/mips/boot/dts/ingenic/ci20.dts | 71 ++++++++++++++++++++------
arch/mips/boot/dts/ingenic/jz4780.dtsi | 2 +
arch/mips/configs/ci20_defconfig | 21 ++++++++
drivers/gpu/drm/ingenic/ingenic-drm.c | 2 +
4 files changed, 80 insertions(+), 16 deletions(-)

--
2.23.0

\
 
 \ /
  Last update: 2020-02-14 17:12    [W:0.073 / U:43.704 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site