lkml.org 
[lkml]   [2020]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ARM: bcm2835_defconfig: add minimal support for Raspberry Pi4
On Fri Feb 14, 2020 at 1:25 PM, Marek Szyprowski wrote:
> Hi Stefan,
>
> On 13.02.2020 10:59, Stefan Wahren wrote:
> > On 13.02.20 08:35, Marek Szyprowski wrote:
> >> On 12.02.2020 19:31, Nicolas Saenz Julienne wrote:
> >>> On Wed, 2020-02-12 at 11:20 +0100, Marek Szyprowski wrote:
> >>>> Add drivers for the minimal set of devices needed to boot Raspberry Pi4
> >>>> board.
> >>>>
> >>>> Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
> >>> Just so you know, the amount of support on the RPi4 you might be able to get
> >>> updating bcm2835_defconfig's config is very limited. Only 1GB of ram and no
> >>> PCIe (so no USBs).
> >> Yes, I know. A lots of core features is missing: SMP, HIGHMEM, LPAE, PCI
> >> and so on, but having a possibility to boot RPi4 with this defconfig
> >> increases the test coverage.
> > in case you want to increase test coverage, we better enable all
> > Raspberry Pi 4 relevant hardware parts (hwrng, thermal, PCI ...). This
> > is what we did for older Pi boards.
>
> Okay, I will add thermal in v2. HWRNG is already selected as module.
> Enabling PCI without LPAE makes no sense as the driver won't be able to
> initialize properly.

Agree on this.

> > SMP, HIGHMEM, LPAE are different and shouldn't be enabled in
> > bcm2835_defconfig from my PoV.
>
> Maybe it would make sense to also add bcm2711_defconfig or
> bcm2835_lpae_defconfig?

IMO bcm2711_defconfig if the last resort solution. I don't think you can
do bcm2835_lpae_defconfig as RPi and RPi2 SoCs don't support LPAE. An
intemediate solution is being discussed here:
https://lkml.org/lkml/2020/1/10/694

Regards,
Nicolas

\
 
 \ /
  Last update: 2020-02-14 16:18    [W:0.099 / U:6.624 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site