lkml.org 
[lkml]   [2020]   [Feb]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 08/12] MIPS: DTS: CI20: add DT node for IR sensor
Date
From: Alex Smith <alex.smith@imgtec.com>

The infrared sensor on the CI20 board is connected to a GPIO and can
be operated by using the gpio-ir-recv driver. Add a DT node for the
sensor to allow that driver to be used.

Signed-off-by: Alex Smith <alex.smith@imgtec.com>
Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
---
arch/mips/boot/dts/ingenic/ci20.dts | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/arch/mips/boot/dts/ingenic/ci20.dts b/arch/mips/boot/dts/ingenic/ci20.dts
index e1364f941c7d..b4a820313992 100644
--- a/arch/mips/boot/dts/ingenic/ci20.dts
+++ b/arch/mips/boot/dts/ingenic/ci20.dts
@@ -62,6 +62,11 @@
enable-active-high;
};

+ ir: ir-receiver {
+ compatible = "gpio-ir-receiver";
+ gpios = <&gpe 3 GPIO_ACTIVE_LOW>;
+ };
+
wlan0_power: fixedregulator@1 {
compatible = "regulator-fixed";
regulator-name = "wlan0_power";
--
2.23.0
\
 
 \ /
  Last update: 2020-02-14 18:20    [W:0.097 / U:5.688 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site