lkml.org 
[lkml]   [2020]   [Feb]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] arm64: dts: ls1028a: add missing SPI nodes
Date
The LS1028A has three (dual) SPI controller. These are compatible with
the ones from the LS1021A. Add the nodes.

This was tested on a custom board.

Signed-off-by: Michael Walle <michael@walle.cc>
---
.../arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 39 +++++++++++++++++++
1 file changed, 39 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
index 36007d07ac6d..302f353e57db 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
@@ -290,6 +290,45 @@
status = "disabled";
};

+ dspi0: spi@2100000 {
+ compatible = "fsl,ls1021a-v1.0-dspi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x0 0x2100000 0x0 0x10000>;
+ interrupts = <GIC_SPI 26 IRQ_TYPE_LEVEL_HIGH>;
+ clock-names = "dspi";
+ clocks = <&clockgen 4 1>;
+ spi-num-chipselects = <4>;
+ little-endian;
+ status = "disabled";
+ };
+
+ dspi1: spi@2110000 {
+ compatible = "fsl,ls1021a-v1.0-dspi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x0 0x2110000 0x0 0x10000>;
+ interrupts = <GIC_SPI 26 IRQ_TYPE_LEVEL_HIGH>;
+ clock-names = "dspi";
+ clocks = <&clockgen 4 1>;
+ spi-num-chipselects = <4>;
+ little-endian;
+ status = "disabled";
+ };
+
+ dspi2: spi@2120000 {
+ compatible = "fsl,ls1021a-v1.0-dspi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x0 0x2120000 0x0 0x10000>;
+ interrupts = <GIC_SPI 26 IRQ_TYPE_LEVEL_HIGH>;
+ clock-names = "dspi";
+ clocks = <&clockgen 4 1>;
+ spi-num-chipselects = <3>;
+ little-endian;
+ status = "disabled";
+ };
+
esdhc: mmc@2140000 {
compatible = "fsl,ls1028a-esdhc", "fsl,esdhc";
reg = <0x0 0x2140000 0x0 0x10000>;
--
2.20.1
\
 
 \ /
  Last update: 2020-02-13 19:57    [W:0.029 / U:31.136 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site