lkml.org 
[lkml]   [2020]   [Feb]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] counter: stm32-timer-cnt: add power management support
From
Date
On 2/10/20 6:45 PM, William Breathitt Gray wrote:
> On Mon, Feb 10, 2020 at 06:19:58PM +0100, Fabrice Gasnier wrote:
>> Add suspend/resume PM sleep ops. When going to low power, enforce the
>> counter isn't active. Gracefully restore its state upon resume in case
>> it's been left enabled prior to suspend.
>>
>> Acked-by: William Breathitt Gray <vilhelm.gray@gmail.com>
>> Signed-off-by: Fabrice Gasnier <fabrice.gasnier@st.com>
>> ---
>> Changes in v2:
>> - Don't refuse to suspend in case the counter has been left enabled.
>> Gracefully disable it and restore its state upon resume.
>> ---
>> drivers/counter/stm32-timer-cnt.c | 63 +++++++++++++++++++++++++++++++++++++++
>> 1 file changed, 63 insertions(+)
>>
>> diff --git a/drivers/counter/stm32-timer-cnt.c b/drivers/counter/stm32-timer-cnt.c
>> index 3eafcce..50496f4 100644
>> --- a/drivers/counter/stm32-timer-cnt.c
>> +++ b/drivers/counter/stm32-timer-cnt.c
>> @@ -12,6 +12,7 @@
>> #include <linux/iio/types.h>
>
> Unrelated to your patch but it caught my eye: are iio headers necessary
> for this file? I suspect they are not needed since this driver does not
> make use of the IIO interface.

Hi William,

Yes, you're right. Thanks for pointing this!
I'll push a patch on top of this one to fix it. BTW, I'm not sure if
this needs to be a marked as a fix, as this seems a quite minor issue?

Best Regards,
Fabrice

>
> William Breathitt Gray
>
>> #include <linux/mfd/stm32-timers.h>
>> #include <linux/module.h>
>> +#include <linux/pinctrl/consumer.h>
>> #include <linux/platform_device.h>
>>
>> #define TIM_CCMR_CCXS (BIT(8) | BIT(0))
>> @@ -20,11 +21,20 @@
>> #define TIM_CCER_MASK (TIM_CCER_CC1P | TIM_CCER_CC1NP | \
>> TIM_CCER_CC2P | TIM_CCER_CC2NP)
>>
>> +struct stm32_timer_regs {
>> + u32 cr1;
>> + u32 cnt;
>> + u32 smcr;
>> + u32 arr;
>> +};
>> +
>> struct stm32_timer_cnt {
>> struct counter_device counter;
>> struct regmap *regmap;
>> struct clk *clk;
>> u32 ceiling;
>> + bool enabled;
>> + struct stm32_timer_regs bak;
>> };
>>
>> /**
>> @@ -224,6 +234,9 @@ static ssize_t stm32_count_enable_write(struct counter_device *counter,
>> clk_disable(priv->clk);
>> }
>>
>> + /* Keep enabled state to properly handle low power states */
>> + priv->enabled = enable;
>> +
>> return len;
>> }
>>
>> @@ -358,10 +371,59 @@ static int stm32_timer_cnt_probe(struct platform_device *pdev)
>> priv->counter.num_signals = ARRAY_SIZE(stm32_signals);
>> priv->counter.priv = priv;
>>
>> + platform_set_drvdata(pdev, priv);
>> +
>> /* Register Counter device */
>> return devm_counter_register(dev, &priv->counter);
>> }
>>
>> +static int __maybe_unused stm32_timer_cnt_suspend(struct device *dev)
>> +{
>> + struct stm32_timer_cnt *priv = dev_get_drvdata(dev);
>> +
>> + /* Only take care of enabled counter: don't disturb other MFD child */
>> + if (priv->enabled) {
>> + /* Backup registers that may get lost in low power mode */
>> + regmap_read(priv->regmap, TIM_SMCR, &priv->bak.smcr);
>> + regmap_read(priv->regmap, TIM_ARR, &priv->bak.arr);
>> + regmap_read(priv->regmap, TIM_CNT, &priv->bak.cnt);
>> + regmap_read(priv->regmap, TIM_CR1, &priv->bak.cr1);
>> +
>> + /* Disable the counter */
>> + regmap_update_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN, 0);
>> + clk_disable(priv->clk);
>> + }
>> +
>> + return pinctrl_pm_select_sleep_state(dev);
>> +}
>> +
>> +static int __maybe_unused stm32_timer_cnt_resume(struct device *dev)
>> +{
>> + struct stm32_timer_cnt *priv = dev_get_drvdata(dev);
>> + int ret;
>> +
>> + ret = pinctrl_pm_select_default_state(dev);
>> + if (ret)
>> + return ret;
>> +
>> + if (priv->enabled) {
>> + clk_enable(priv->clk);
>> +
>> + /* Restore registers that may have been lost */
>> + regmap_write(priv->regmap, TIM_SMCR, priv->bak.smcr);
>> + regmap_write(priv->regmap, TIM_ARR, priv->bak.arr);
>> + regmap_write(priv->regmap, TIM_CNT, priv->bak.cnt);
>> +
>> + /* Also re-enables the counter */
>> + regmap_write(priv->regmap, TIM_CR1, priv->bak.cr1);
>> + }
>> +
>> + return 0;
>> +}
>> +
>> +static SIMPLE_DEV_PM_OPS(stm32_timer_cnt_pm_ops, stm32_timer_cnt_suspend,
>> + stm32_timer_cnt_resume);
>> +
>> static const struct of_device_id stm32_timer_cnt_of_match[] = {
>> { .compatible = "st,stm32-timer-counter", },
>> {},
>> @@ -373,6 +435,7 @@ static struct platform_driver stm32_timer_cnt_driver = {
>> .driver = {
>> .name = "stm32-timer-counter",
>> .of_match_table = stm32_timer_cnt_of_match,
>> + .pm = &stm32_timer_cnt_pm_ops,
>> },
>> };
>> module_platform_driver(stm32_timer_cnt_driver);
>> --
>> 2.7.4
>>

\
 
 \ /
  Last update: 2020-02-11 11:55    [W:0.063 / U:0.404 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site