lkml.org 
[lkml]   [2020]   [Dec]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH RFC 1/2] Documentation: devicetree: Add property for ignoring the dummy bits sent before read transfer
Date
Dummy zero bits are sent before data during a read transfer. This causes
the data read to be shifted to the right. To fix this send zero bits after
the address during a read transfer.

Add property to send zero bits after the address during a read transfer.

Suggested-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
---
Documentation/devicetree/bindings/misc/eeprom-93xx46.txt | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/misc/eeprom-93xx46.txt b/Documentation/devicetree/bindings/misc/eeprom-93xx46.txt
index a8ebb4621f79..09fb1cec54f0 100644
--- a/Documentation/devicetree/bindings/misc/eeprom-93xx46.txt
+++ b/Documentation/devicetree/bindings/misc/eeprom-93xx46.txt
@@ -10,7 +10,9 @@ Optional properties:
- read-only : parameter-less property which disables writes to the EEPROM
- select-gpios : if present, specifies the GPIO that will be asserted prior to
each access to the EEPROM (e.g. for SPI bus multiplexing)
-
+- read-op-dummy-cycles: If present specifies the number of dummy zero-bits to
+ be sent after the address during a read transfer to ignore any bits sent
+ preceding the data.
Property rules described in Documentation/devicetree/bindings/spi/spi-bus.txt
apply. In particular, "reg" and "spi-max-frequency" properties must be given.

--
2.17.1
\
 
 \ /
  Last update: 2020-12-09 18:58    [W:0.063 / U:0.816 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site