lkml.org 
[lkml]   [2020]   [Dec]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v10 3/3] arm64: dts: sparx5: Add SGPIO devices
Date

Andrew Lunn writes:

> On Fri, Nov 13, 2020 at 03:51:51PM +0100, Lars Povlsen wrote:
>> + led@8 {
>> + label = "eth12:green";
>> + gpios = <&sgpio_out0 12 0 GPIO_ACTIVE_HIGH>;
>> + default-state = "off";
>> + };
>> + led@9 {
>> + label = "eth12:yellow";
>> + gpios = <&sgpio_out0 12 1 GPIO_ACTIVE_HIGH>;
>> + default-state = "off";
>> + };
>
> Hi Lars
>
> I did not see these patches earlier, but i've been looking at the
> switch driver patches recently, so went digging.
>
> Can the Ethernet switch itself control these LEDs for indicating
> things like packet receive/transmit, link state, and link speed? Or
> are they purely software controlled?
>
> Thanks
> Andrew

Hi Andrew!

No, the SGPIO device is separate from the switch device as such. I was
planning to couple the two by means of "led events" in a later patch.

---Lars

--
Lars Povlsen,
Microchip

\
 
 \ /
  Last update: 2020-12-22 11:12    [W:0.082 / U:0.256 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site