[lkml]   [2020]   [Dec]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCHv2 1/5] firmware: stratix10-svc: add COMMAND_AUTHENTICATE_BITSTREAM flag
Hi Richard,

On Tue, Dec 01, 2020 at 01:30:16PM -0600, Richard Gong wrote:

> > Can U-Boot determine whether it's the new or old flow? Can you set a
> > different compatible value in your device-tree, to disambiguate
> > behaviors?
> >
> The boot flow is determined by defconfig during compilation, which means
> each boot flow will have its own defconfig.
> SDM firmware loads SPL into OCRAM, then SPL will load the apporiate ATF or
> U-boot into the DRAM according to the setting of CONFIG_SPL_ATF. If
> CONFIG_SPL_ATF=y, SPL loads ATF and then jumps to ATF. ATF setups EL3
> environment and initialize the PSCI services.
> CONFIG_SPL_ATF is not set for the old boot flow.

So you know at (U-Boot) build time? Can you just pass a different DT to
the kernel in that case?

- Moritz

 \ /
  Last update: 2020-12-01 20:21    [W:0.066 / U:0.440 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site