lkml.org 
[lkml]   [2020]   [Nov]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] drivers: qcom: rpmh-rsc: Do not read back the register write on trigger
Date
From: Lina Iyer <ilina@codeaurora.org>

When triggering a TCS to send its contents, reading back the trigger
value may return an incorrect value. That is because, writing the
trigger may raise an interrupt which could be handled immediately and
the trigger value could be reset in the interrupt handler.

A write_tcs_reg_sync() would read back the value that is written and try
to match it to the value written to ensure that the value is written,
but if that value is different, we may see false error for same.

Signed-off-by: Lina Iyer <ilina@codeaurora.org>
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
---
drivers/soc/qcom/rpmh-rsc.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/soc/qcom/rpmh-rsc.c b/drivers/soc/qcom/rpmh-rsc.c
index 37969dc..0b082ec 100644
--- a/drivers/soc/qcom/rpmh-rsc.c
+++ b/drivers/soc/qcom/rpmh-rsc.c
@@ -364,7 +364,7 @@ static void __tcs_set_trigger(struct rsc_drv *drv, int tcs_id, bool trigger)
enable = TCS_AMC_MODE_ENABLE;
write_tcs_reg_sync(drv, RSC_DRV_CONTROL, tcs_id, enable);
enable |= TCS_AMC_MODE_TRIGGER;
- write_tcs_reg_sync(drv, RSC_DRV_CONTROL, tcs_id, enable);
+ write_tcs_reg(drv, RSC_DRV_CONTROL, tcs_id, enable);
}
}

--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
\
 
 \ /
  Last update: 2020-11-24 10:54    [W:0.051 / U:0.352 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site