lkml.org 
[lkml]   [2020]   [Nov]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH v2 03/11] dt-bindings:iio:adc:remove atmel,adc-res and atmel,adc-res-names
    Date
    Remove atmel,adc-res and atmel,adc-res-names as they are not necessary and
    are handled by the driver. Also add sama5d3 to the list of possible chips.

    Cc: Rob Herring <robh+dt@kernel.org>
    Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
    ---
    .../devicetree/bindings/iio/adc/at91_adc.txt | 13 ++++---------
    1 file changed, 4 insertions(+), 9 deletions(-)

    diff --git a/Documentation/devicetree/bindings/iio/adc/at91_adc.txt b/Documentation/devicetree/bindings/iio/adc/at91_adc.txt
    index f65b04fb7962..da393ac5c05f 100644
    --- a/Documentation/devicetree/bindings/iio/adc/at91_adc.txt
    +++ b/Documentation/devicetree/bindings/iio/adc/at91_adc.txt
    @@ -2,7 +2,7 @@

    Required properties:
    - compatible: Should be "atmel,<chip>-adc"
    - <chip> can be "at91sam9260", "at91sam9g45" or "at91sam9x5"
    + <chip> can be "at91sam9260", "at91sam9g45", "at91sam9x5" or "sama5d3"
    - reg: Should contain ADC registers location and length
    - interrupts: Should contain the IRQ line for the ADC
    - clock-names: tuple listing input clock names.
    @@ -13,17 +13,12 @@ Required properties:
    - atmel,adc-startup-time: Startup Time of the ADC in microseconds as
    defined in the datasheet
    - atmel,adc-vref: Reference voltage in millivolts for the conversions
    - - atmel,adc-res: List of resolutions in bits supported by the ADC. List size
    - must be two at least.
    - - atmel,adc-res-names: Contains one identifier string for each resolution
    - in atmel,adc-res property. "lowres" and "highres"
    - identifiers are required.

    Optional properties:
    - atmel,adc-use-external-triggers: Boolean to enable the external triggers
    - - atmel,adc-use-res: String corresponding to an identifier from
    - atmel,adc-res-names property. If not specified, the highest
    - resolution will be used.
    + - atmel,adc-use-res: String selecting the resolution, can be "lowres" or
    + "highres". If not specified, the highest resolution will
    + be used.
    - atmel,adc-sleep-mode: Boolean to enable sleep mode when no conversion
    - atmel,adc-sample-hold-time: Sample and Hold Time in microseconds
    - atmel,adc-ts-wires: Number of touchscreen wires. Should be 4 or 5. If this
    --
    2.28.0
    \
     
     \ /
      Last update: 2020-11-17 15:10    [W:3.371 / U:0.000 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site