lkml.org 
[lkml]   [2020]   [Oct]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v4 1/3] dt-bindings: pinctrl: Add bindings for pinctrl-mchp-sgpio driver
Date

Linus Walleij writes:

> Hi Lars,
>
> a new version of the patch set arrives while I'm reviewing, haha :D

Well, luckily not too much changed per Rob's input.

>
> On Wed, Oct 7, 2020 at 1:12 PM Lars Povlsen <lars.povlsen@microchip.com> wrote:
>
>> This adds DT bindings for the Microsemi/Microchip SGPIO controller,
>> bindings microchip,sparx5-sgpio, mscc,ocelot-sgpio and
>> mscc,luton-sgpio.
>>
>> Signed-off-by: Lars Povlsen <lars.povlsen@microchip.com>
>
> (...)
>> + reg:
>> + description: |
>> + The GPIO bank number. "0" is designates the input pin bank,
>> + "1" the output bank.
>> + maxItems: 1
>
> Excellent.
>
>> + '#gpio-cells':
>> + const: 3
>
> So I thought you needed three cells exactly because the
> middle cell would get you the bank. That you now have in
> reg. So what about using the standard twocell?

I think I answered that in the 'v3 2/3' reply.

Basically the pins are addressed with two indices, and there are good
reasons to expose these to the GPIO cells, f.ex. hardware documentation
cross reference.

---Lars

>
> Yours,
> Linus Walleij

--
Lars Povlsen,
Microchip

\
 
 \ /
  Last update: 2020-10-08 13:45    [W:0.057 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site