Messages in this thread Patch in this message | | | From | Michal Simek <> | Subject | [PATCH v2 8/8] arm64: zynqmp: Setup default number of chipselects for zcu100 | Date | Thu, 9 Jan 2020 14:52:22 +0100 |
| |
There is only one chipselect on each connector. Define it directly in board dts file. There should be an option to use more chipselects via gpios.
Signed-off-by: Michal Simek <michal.simek@xilinx.com> ---
Changes in v2: None
arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 2 ++ 1 file changed, 2 insertions(+)
diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts index 2b3757dd74cc..a109e82982ae 100644 --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts @@ -250,11 +250,13 @@ wlcore: wifi@2 { &spi0 { /* Low Speed connector */ status = "okay"; label = "LS-SPI0"; + num-cs = <1>; }; &spi1 { /* High Speed connector */ status = "okay"; label = "HS-SPI1"; + num-cs = <1>; }; &uart0 { -- 2.24.0
| |