lkml.org 
[lkml]   [2020]   [Jan]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] drivers: pci: Clear ACS state at kexec
On 2020-01-04 3:51 p.m., Deepa Dinamani wrote:
> ACS bits remain sticky through kexec reset. This is not really a
> problem for Linux because turning IOMMU on assumes ACS on. But,
> this becomes a problem if we kexec into something other than
> Linux and that does not turn ACS on always.
>
> Reset the ACS bits to default before kexec or device remove.

Hmm, I'm slightly hesitant about disabling ACS on a device's unbind...
Not sure if that's going to open up a hole on us.

> +
> +/* Standard PCI ACS capailities
> + * Source Validation | P2P Request Redirect | P2P Completion Redirect | Upstream Forwarding
> + */
> +#define PCI_STD_ACS_CAP (PCI_ACS_SV | PCI_ACS_RR | PCI_ACS_CR | PCI_ACS_UF)
> +
> /**
> - * pci_std_enable_acs - enable ACS on devices using standard ACS capabilities
> + * pci_std_enable_disable_acs - enable/disable ACS on devices using standard
> + * ACS capabilities
> * @dev: the PCI device
> */
> -static void pci_std_enable_acs(struct pci_dev *dev)
> +static void pci_std_enable_disable_acs(struct pci_dev *dev, int enable)
> {
> int pos;
> u16 cap;
> u16 ctrl;
> + u16 val = 0;
>
> pos = pci_find_ext_capability(dev, PCI_EXT_CAP_ID_ACS);
> if (!pos)
> @@ -3278,19 +3286,26 @@ static void pci_std_enable_acs(struct pci_dev *dev)
> pci_read_config_word(dev, pos + PCI_ACS_CAP, &cap);
> pci_read_config_word(dev, pos + PCI_ACS_CTRL, &ctrl);
>
> - /* Source Validation */
> - ctrl |= (cap & PCI_ACS_SV);
> + val = (cap & PCI_STD_ACS_CAP);

Can we open code PCI_STD_ACS_CAP? I don't see any value in it being
defined above the function, it just makes the code harder to read.

Logan

\
 
 \ /
  Last update: 2020-01-06 17:52    [W:0.047 / U:0.440 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site