lkml.org 
[lkml]   [2020]   [Jan]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v10 11/13] gpio: bd71828: Initial support for ROHM BD71828 PMIC GPIOs
On Fri, 17 Jan 2020, Matti Vaittinen wrote:

> ROHM BD71828 PMIC contains 4 pins which can be configured by OTP
> to be used for general purposes. First 3 can be used as outputs
> and 4.th pin can be used as input. Allow them to be controlled
> via GPIO framework.
>
> The driver assumes all of the pins are configured as GPIOs and
> trusts that the reserved pins in other OTP configurations are
> excluded from control using "gpio-reserved-ranges" device tree
> property (or left untouched by GPIO users).
>
> Typical use for 4.th pin (input) is to use it as HALL sensor
> input so that this pin state is toggled when HALL sensor detects
> LID position change (from close to open or open to close). PMIC
> HW implements some extra logic which allows PMIC to power-up the
> system when this pin is toggled. Please see the data sheet for
> details of GPIO options which can be selected by OTP settings.
>
> Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
> Reviewed-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>

> Reviewed-by: Linus Walleij <linus.walleij@linaro.org>

Linus, Is that an Ack?

> ---
> no changes since v9
>
> drivers/gpio/Kconfig | 12 +++
> drivers/gpio/Makefile | 1 +
> drivers/gpio/gpio-bd71828.c | 159 ++++++++++++++++++++++++++++++++++++
> 3 files changed, 172 insertions(+)
> create mode 100644 drivers/gpio/gpio-bd71828.c

--
Lee Jones [李琼斯]
Linaro Services Technical Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog

\
 
 \ /
  Last update: 2020-01-17 11:22    [W:0.424 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site